CONNECTING PERIPHERAL EQUIPMENT
Video Recorder : Playback
Connect the RF cable to the RF socket on your video recorder.
1
EXTINTANTENNA IN 75& SWITCH
+_AV5-RGB, 480p/1080i-60Hz, 576p-50Hz
CENTER CHANNEL AMP INPUT
Connect another RF cable from the output of your videoAV4-480p/1080i-60Hz, 576p-50HzG/Y
INPUT-AV 1MONITORINPUT-AV 2SUBWOOFERR/Pr
S-VIDEOLVIDEOLPbYOUTVIDEOLS-VIDEOLB/PbVLLCABLE
recorder to the ANTENNA IN 75& socket on your TV.AUDIORAUDIOSYNCAUDIOPrRHRAUDIOR
2
Better playback quality can be obtained if you also connect the
1
Video,Audio Left and Right (only for stereo equipment) cables to
3
the VIDEO and AUDIO L (mono) and R inputs of
INPUT-AV 2.
Note : In case of mono equipment, only the left loudspeaker
reproduces sound. Use a mono-to-stereo adapter (not supplied)23
for sound reproduction via the internal loudspeakers.
The MONITOR OUT connectors can be used for daisy chainingA/V OUT
RF OUTRF IN
or recording programmes from your TV. See page 23.
S-VHS-Video quality with an S-VHS video recorder is obtained by
connecting the S-VHS-Video cable with the S-VIDEO input instead
of connecting the video recorder to the VIDEO input. See theVIDEO RECORDER
handbook for the video recorder.
If You Do Not Make the Video and Audio
Connections in Step 3 Above :
Search for and store the test signal of the video recorder.
Unplug the RF cable from the RF socket of your video recorder.
1
Switch on your TV and put the video recorder on the test signal
or play a prerecorded tape. See the handbook for your video
2
recorder.
Search for the test signal of your video recorder in the same way
you searched for and stored the TV signals. See pages 9 and 10.
3
Store the test signal under programme number 0 or between 90
4and 99.
Replace the RF cable in the RF socket of your video recorder
after you have stored the test signal.
5
22 |
ACEC
