Using the On-screen Submenus: Picture
ADJUSTINGTHE MANUAL CONVERGE CONTROLS:CONVERGE RED/BLUE
s explained in the Quick Use and Setup
AGuide, your projection TVhas three color
PICTURE
projection tubes: one for red, one for green, and
MANUAL CONVERGE
one for blue. When mixed in proper proportion,
CONVERGE RED
the beams of light coming from the tubes can
CONVERGE BLUE
produce any color. To create a clear picture,
MULTIPOINT RED
however, these color beams must be preciselyMULTIPOINT BLUE
aligned. This alignment is called convergence.SAVE MULTIPOINT
Bumps and vibrations, moving the set, or the
presence of magnetic fields can cause the colorConverge Red
beams to become improperly aligned, or mis-
converged, resulting in a fuzzy picture. Using
the Auto IntelliSenseafeature, you can auto-POWER
matically adjust convergence in 20 seconds or
less. See page 7 in the Quick Use and Setup
Guide. Also, if you desire, you can use the
MANUALCONVERGEcontrolsNexplained on
this page and the nextNto make additional con-TVVCRACC
ACTIVE
vergence adjustments to suit your personal prSWAPef-PIP CHCONTROL FREEZE
Converge Red
erences or to further fine-tune the picture. SeeDNUP
2,3
the chart to the right to determine which SOUNDPICTURE
MANUALCONVERGE controls to use for cur-
rent picture conditions.
STATUS/MENU/Determining Which
EXITSELECT
NOTE:Allow the TVto warm up for 20 minutesManual Converge
before adjusting convergence.
Control to Use
MUTE
VOLCH
Screen
Press the MENU/SELECT button to1
anppearanceActio
show the on-screen menu. Press the
1Adjust the
CURSOR RING RIGHT to enter the132
CONVERGE
PICTURE submenu. Then press the
465VariousRED control.
CURSOR RING DOWN repeatedly until
imagesThen if any red
MANUAL CONVERGE is highlighted.
798
throughoutoutlines remain,
Press the CURSOR RING RIGHTtoTV/VCR
A/CH0SURFthe entireadjust the
enter the MANUAL CONVERGE
2picture haveMULTIPOINT
submenu. If you want to adjust the Red
POSITIONPIPred outlines.RED control.
Convergence, press the CURSOR RING
RIGHT to enter the adjust mode. ToAdjust the
adjust the Blue Convergence, press theCONVERGE
CURSOR RING DOWN to highlightVariousBLUE control.
CONVERGE BLUE, then press theimagesThen if any blue
CURSOR RING RIGHT to enter adjustthroughoutoutlines remain,
mode.the entireadjust the
picture haveMULTIPOINT
In adjust mode, press the CURSOR
blue outlines.BLUE control.
RING RIGHT, LEFT, UP, or DOWN
3
to adjust the cross hair until the color
outline around it is gone. (The adjust-
ment is automatically saved in the TVOs
memory.) To return to the MANUAL
CONVERGE menu, press the
MENU/SELECT button. To exit the on-
screen display, press the STATUS/EXIT
button.
33 |
ACEC
