14ENGLISHENGLISH15
Placing or removing razor from� An adaptor plug may be necessary for
charging stand:charging plug usage in some foreign countries.
Use an attachment plug adaptor of the proper
configuration for the power outlet.
C�Always place razor in stand in an upright The charging plug will automatically convert to
position making sure charging contacts inwork on 100V to 240V AC systems.
bottom of stand fit into recess in bottom of
razor.2First time charging and recharging after
non-use for 1 month or more requires a
full 4 hours. A fully charged razor has a
C�Always remove razor from stand by liftingcordless shaving time of up to 30 days.
straight up. Do not tilt razor.When batteries are fully charged, all the Olights� in
the display will light up green. A few hours after
� Do not leave the charging stand with thecharging, all lights go off.
razor in it continuously plugged into outlet as
it would reduce life of batteries. If storingRecharging
razor in stand, remove the plug from outlet as
soon as the razor is fully charged.1First time charging requires 4 hours. After
initial charge, recharging requires 1 hour.
C 1 Connect cord directly to razor or placeRecharge only when the bottom light on the
razor in charging stand and connect thedisplay lights up red.
small plug of cord to charging stand.
Connect the charging plug into any 100VC2When razor is fully charged, disconnect
to 240V AC outlet. Use only the chargingthe charging plug from outlet.
plug provided.Do not keep razor or charging stand permanently
plugged into outlet. If using charging stand, always
As you charge razor, the bottom light on theremove razor from stand by lifting straight up. Do
display turns red. After approximately 3 minutes,not tilt razor.
it will then turn green and blink. As charging
continues, more and more lights of the display
meter will briefly blink green and light up to
indicate what level of the batteries have been
charged. |
ACEC
