Power supplyClock and Date
Power supply � When time signal is received,dis-
Make sure you remove the plug from the setplays. If no signal is received,will
and wall outlet before inserting batteries.display.
Batteries (not supplied) for the mainTo adjust to your local time
unit and the outdoor sensor
? If you didnt previously adjust to your local
1 Open the battery door and insert 4 batteries,time, or the set is reconnected to power, the
typed AAA for the main unit, and 2 batteries
time searched by RCC is Central European
typed AA for the sensor, with the correcttime.To adjust the time to your local time,
polarity as indicated by the "+" and "?" sym-
bols inside the compartment.you need to calculate the time zone differ-
ence between your local time and the central
2 Replace the battery door, making sure the
European time, and do the steps described in
batteries are firmly and correctly in place.TheŤ Manual setting .
set is now ready to operate.
Helpful hints:
Batteries contain chemical substances,so
they should be disposed of properly.? The searching will stop 10 minutes later if no
time signal is received.
Mains Adapter.? RCC time will auto be updated at 2: 00 am
Note: Remove the batteries beforeevery day.You dont need to re-adjust to your
you use the AC adapter.local time if the set already shows your local
1 Connect the mains adapter to the set's DCtime.
7.5V socket and to the power socket.Manual setting
Helpful hints:You may also set or adjust time manually.
To avoid damage to the set, use only the
adapter supplied!1 Press and hold TIME SET / RCC SYNC
for 2 seconds.
The type plate is located on the bottom� The digits for year flash.
of the set.
2 Hold down or press TUNING +/- repeat-
edly to adjust the time digits.
Setting the clock and date ? If the set currently shows the central
(see 2)European time, add or subtract by hour(s)
The clock uses 24-hour time format.the time zone difference from your local time.
Auto setting (RCC - Radio Controlled? When it comes to adjust month and day, you
Clock)may press AUTO SCAN/DATE to change
The set has a built-in radio controlled clockthe display order between month and day.
(RCC).The clock automatically synchronizes
the current time and date when it is brought3 Press TIME SET / RCC SYNC to confirm
within the range of the radio signalthe setting.
DCF77.5KHz generated from Frankfurt,� The digits for month flashes.
Germany, for Central Europe.4 Repeat steps 2-3 to complete all the other
1 For the first time when the set is poweredsettings for month, day, hour and minute.
on, or reconnected to power, the set will autoHelpful hints:
perform RCC searching.
Or, to perform RCC searching, press briefly? If you already adjust the time to your local
time, RCC time searching will auto update to
TIME SET / RCC SYNC.
� The will display flashing, indicatingyour local time.
RCC searching is in progress (See 3).Standby power consumption
(clock mode).........................................................1.5W |
ACEC
