XP AJ3010/00 20-06-2000 16:33 Pagina 6
BASIC FEATURES
EnglishILLUMINATION BRIGHTNESSRADIO
Press REPEAT ALARM/ BRIGHTNESSCONTROL once or more.1. Press SLEEP / RADIO ON once to switch on the radio.
" The brightness of the display will change in this sequence:2. Select your waveband using the BAND switch.
BRIGHT ź DIM ź BRIGHT...3. Use TUNING to find your radio station.
Note:4. Adjust the sound using VOLUME.
When an alarm or the SLEEP function is active, brightness5. Press ALARM RESET / RADIO OFF to switch off.
cannot be adjusted.
To improve reception:
SETTING THE CLOCKFM: extend and position the pigtail aerial to obtain optimum
The time is displayed using the 24 hour clock. reception.
1. Press TIME SET for more than 2 seconds to enter timeMW (or LW): uses a built-in antenna inside the set. Direct
setting mode.the antenna by adjusting the position of your set.
" Time displays and flash.
2. Press HR or MIN repeatedly or hold down on the button toSETTING THE ALARM
General
adjust the hours and minutes respectively. Release HR orIf you wish to use the alarm, first set the alarm time.
MIN when you reach the correct setting.There is a choice of two alarm modes, buzzer or radio. The
3. After you have set both the hours and minutes, alarm display shows the alarm time all the time and the alarm
press TIME SET to confirm the correct setting.indicator appears if the alarm is set.
" Clock time also starts to run automatically after
60 seconds after you adjust the time.
Note:
Press ALARM SET during time setting will switch to alarm
setting mode.
6 |