CAJ3080/00 page 7
TROUBLESHOOTING
� If a fault occurs, first check the points listed below before taking the set for repair.
� If you are unable to remedy a problem by following the hints below, consult your dealer or service
Englishcentre.
WARNING: under no circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
PROBLEMThe alarm does not function
� POSSIBLE CAUSE� The alarm is not set
Y REMEDYY Set the alarm time and the alarm switch to
BUZor RAD.
No sound
� Volume not adjusted.� Volume too low for radio.
Y Adjust the volume.Y Increase the volume.
The slumber does not function
MW (LW) broadcast cannot be received� RADIO still in ON position.
properlyY Switch RADIO to OFF position.
� Weak radio signal.� Clock control in TIME SET or ALARM position.
Y Adjust clock control to RUN position.
Y Rotate the set for better reception and make
sure the set is placed on a non-metallic
surface.
Continuous crackling and hiss noise during
MW (LW) reception
� Interference from other electrical equipment
e.g. TVOs, computers, fluorescent lamps.
Y Move the clock radio away from electricalENVIRONMENTAL INFORMATION
equipment.
All unnecessary packaging material has been
Intermittent crackling sound during FMomitted. We have tried to make the packaging
receptioneasy to separate into three mono-materials:
� Weak signal.cardboard (box), expandable polystyrene (buffer),
Y Adjust the pigtail aerial.polyethylene (bags).
Your set consists of materials which can be
recycled if disassembled by a specialized
company. Please observe the local regulations
regarding the disposal of packing materials,
exhausted batteries and old equipment.
The model and production numbers are located on the bottom of the clock radio.
This set complies with the radio interference requirements of the European Community.
7 |
ACEC
