POWER SUPPLYSETTING THE CLOCKRADIO RECEPTION
EnglishPOWER SUPPLY1Press TIME SET.
Mains Adapter (not included)� The clock digits flash for about 5 seconds when you
The voltage of the 3V adapter must match with the localpress TIME SET.
voltage. The 3.5 mm adapter plug's 1.3 mm centre pin must2To set the hour/minutes, press HOUR or MIN while the
also be connected to the minus pole -.display is still flashing.
Y Connect the mains adapter to the set's DC 3V socket and a� With your finger held down on HOUR, the hour increases
wall socket.steadily as a number from 0-23. Release HOUR when
you reach the correct hour setting.
Y Always disconnect the mains adapter if you are not using
it.� With your finger held down on MIN, the minutes
increase rapidly and continuously. Press briefly and
repeatedly if you need to adjust the minutes slowly.
Battery (not included)
Y Open battery door and insert two alkaline batteries, type� When the clock digits stop flashing, the time is set.
R6, UM3 or AA as indicated.RADIO RECEPTION
Y Remove the batteries from the set if they are exhausted or1Connect headphones to the psocket.
not to be used for a long time.2Press RADIO ON/OFFYBANDto switch on the radio.
� When the batteries are running low, flashes in the3Press RADIO ON/OFFYBANDagain to select AM or FM
display. If the radio is on, it will automatically switch off.waveband.
� It may be necessary to reprogramme your preset stations.� The display shows the radio station details throughout
the radio mode.
SETTING THE CLOCK�FM ST appears on the display when you are receiving a
Clock display
FM stereo transmission.
The time is displayed using the 24-hour clock system. The4Select your station by pressing one of the preset numbers
clock display is shown when the radio and cassette functions
are switched off.(1-5), or by using the TUNING controls + or �.
4 |
ACEC
