XP AZ 1025/17 19-09-2000 13:02 Pagina 16
AZ 1025 /17 page 16
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable
Englishto remedy a problem by following these hints, consult your dealer or service center.
WARNING: Do not open the set as there is a risk of electric shock! Under no
circumstances should you try to repair the set yourself, as this would
invalidate the warranty.
PROBLEMThe CD skips tracks
� POSSIBLE CAUSE� CD is damaged or dirty
Y REMEDYY Replace or clean the CD
� SHUFFLE or PROGRAM is active
No sound/powerY Quit SHUFFLE/PROGRAM mode(s)
� VOLUME is not adjusted
Y Adjust the VOLUMEPoor cassette sound quality
� Headphones are connected� Dust and dirt on the heads, etc
Y Disconnect headphonesY Clean deck parts etc., see maintenance
� Power cord not securely connected� Use of incompatible cassette types (METAL
Y Connect the AC power cord properlyor CHROME)
� Batteries exhausted/incorrectly insertedY Only use NORMAL (IEC I) for recording
Y Insert fresh batteries/ batteries correctlyRecording does not work
� Batteries loaded but power cord still plugged� Cassette tab(s) may be broken out
in and connectedY Apply a piece of adhesive tape over the
Y Detach the power plug from the MAINS jackmissing tab space
and the set
Remote control does not function properly
Poor radio reception� Batteries exhausted/incorrectly inserted
� Weak radio signalY Insert fresh batteries/ batteries correctly
Y FM: extend and aim the telescopic antenna
for best reception;� Distance between the set too large
Y AM: rotate the setY Reduce the distance
CD playback does not work
� CD is badly scratched or dirty
Y Replace or clean the CD, see Maintenance
� Laser lens steamed up
Y Wait until lens has acclimatized
Environmental information
We have reduced the packaging to the minimum and made it easy to separate into three materials:
cardboard (box), expandable polystyrene (buffer), and plastic (bags, protective foam).
Your set consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packing
materials, exhausted batteries and old equipment.
The type plate is located on the bottom of the set.
16 |
ACEC
