Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.Important notes for users in the U.K.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
Mains plug
WARNING:Do not open the set as there is a risk of electric shock.Under no cir-This apparatus is fitted with an approved 13 Amp plug.To change a fuse in this type of
cumstances should you try to repair the set yourself,as this will invali-plug proceed as follows:
date the guarantee.
ProblemThe CD skips tracks1.Remove fuse cover and fuse.
2.Fix new fuse which should be a BS1362 5 Amp, A.S.T.A. or BSI approved type.
No sound /power� CD damaged or dirty
Y Replace or clean CD3.Refit the fuse cover.
� Volume not adjusted
Y Adjust the VOLUME� Shuffle or program is activeIf the fitted plug is not suitable for your socket outlets, it should be cut off and an
Y Switch off shuffle/program
� Power cord not securely connectedappropriate plug fitted in its place. If the mains plug contains a fuse, this should have a
Y Connect the AC power cord properlyPoor cassette sound qualityvalue of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board
� Batteries dead/ incorrectly insertedshould not be greater than 5 Amp.
� Dust and dirt on the heads,etc.
Y Insert (fresh) batteries correctlyY Clean deck parts, see Maintenance
� Headphones connected to the setNote:The severed plug must be disposed of to avoid a possible shock hazard should it
Y Disconnect headphones� Use of incompatible cassette types (METAL orbe inserted into a 13 Amp socket elsewhere.
CHROME)
� CD contains non-audio files
Y Press SEARCH or once or more skipY Only use NORMAL (IEC I) for recordingHow to connect a plug
the data file to a CD audio trackRecording does not workThe wires in the mains lead are coloured with the following code: blue = neutral (N),
brown = live (L). As these colours may not correspond with the colour markings iden-
Display does not function properly/No� Cassette tab(s) may be broken
reaction to operation of any of the con-Y Apply adhesive tape over the missing tab spacetifying the terminals in your plug, proceed as follows:
Y Connect the blue wire to the terminal marked N or coloured black.
trolsY Connect the brown wire to the terminal marked L or coloured red.
� Electrostatic dischargeYDo not connect either wire to the earth terminal in the plug, marked E (or e) or
Y Switch off and unplug the set. Reconnect after acoloured green (or green and yellow).
few secondsBefore replacing the plug cover, make certain that the cord grip is clamped over the
sheath of the lead - not simply over the two wires.
00 indication
� No CD insertedCopyright in the U.K.
Recording and playback of material may require consent. See Copyright Act 1956 and
Y Insert a suitable disc
� CD badly scratched or dirtyThe PerformerOs Protection Acts 1958 to 1972.
Y Replace/clean CD (See Maintenance)
� CD-R(W) is blank or the disc is not finalized.
Y Use a finalized CD-R(W)
� Laser lens steam up
YWait until lens has cleared |
ACEC
