XP AZ 1575/01 05-10-2000 09:23 Pagina 7
AZ 1575 /01 page 7
DIGITAL TUNER
Tuning to radio stations
1. Select TUNER source.
CD
"is displayed briefly and then the radio station frequency RADIO CASSTOSETPTE R7PLAYE5COYPARDEROPEEnglishAZ 15
USE
is shown.
GLBOATWMPROFSOUND CONTROL CENTER
AMPT
2. Press BAND once or more to select your waveband.SSHTROEUFRGFELOVOLUNLWESREEERNMSOOTPRERESET
YY
3. Press SEARCH or § (on the remote control, TUNING SHUFFLEREPBAND
EAT
SEARCH
or §) and release when the frequency in the display starts
running.
" The tuner automatically tunes to a station of sufficient
reception. Display shows during automatic tuning.
" If an FM station is received in stereo, STEREO is shown.
4. Repeat step 3 if necessary until you find the desired station.
Y To tune to a weak station, press SEARCH or § briefly and
repeatedly until you have found optimal reception.
To improve radio reception:
Y For FM, pull out the telescopic aerial.
Incline and turn the aerial. Reduce its length if the signal is too
strong (very close to a transmitter).
Y For MW (AM), the set is provided with a built-in aerial so the
telescopic aerial is not needed. Direct the aerial by turning the
whole set.
Programming radio stations
CD R
You can store up to a total of 30 radio stations in the memory. ADIOA CSTAZSSE OPT1T5EPL 7RE5CAYYPORAUSDEROPE
E
1. Tune to your desired station (see Tuning to radio stations).SOUND CONTROL CENTER
PROGLBOAWTFM
2. Press PROG to activate programming.AMPROSGVOLTUNERLWHUFFLESREENMSOOTPRESET
RE
YY
" Display: PROG flashes.SHUFFLEBAND
REPEAT
SEARCH
3. Press PRESET 3 or 4 once or more to allocate a number from
1 to 30 to this station.
4. Press PROG again to confirm the setting.
" Display: PROG disappears, the preset number and the frequency
of the preset station are shown.
5. Repeat the above four steps to store other stations.
Y You can overwrite a preset station by storing another
frequency in its place.
Tuning to preset stations
Press TUNER PRESET 4 or 3 until the desired preset station is
displayed.
7 |
ACEC
