POWER SUPPLY/BASIC FUNCTIONSDIGITAL TUNER
Batteries contain chemical substances, so2 Press and hold or § ( TUNING + - on the
they should be disposed of properly.remote control) until the frequency in the display
Using AC Mainsstarts running.
1 Check if the mains supply, as shown on the type? The radio automatically tunes to a station of
plate located on the bottom of the set,sufficient reception. Display shows
corresponds to your local mains supply. If it doesduring automatic tuning.
not, consult your dealer or service centre.3 Repeat step 2 if necessary until you find the
2 If your set is equipped with a voltage selector,desired station.
adjust the selector so that it matches with the? To tune to a weak station, press or §
local power supply. ( TUNING + - on the remote control) briefly and
3 Connect the power cord to the AC MAINS ~ inletrepeatedly until you have found optimal reception.
and the wall socket. The set is now ready for use. To improve radio reception:
4 To switch the set off completely, withdraw the? For FM, extend, incline and turn the telescopic
power cord from the wall socket. aerial. Reduce its length if the signal is too strong.
5 Install the unit near the AC outlet and where the? For MW, the set uses a built-in aerial. Direct this
AC power plug can be easily reached.aerial by turning the whole set.
? Disconnect the power cord from the wall socket to
Programming radio stations
protect your set during heavy thunderstorms.
Children could seriously injure themselves as theYou can store up to a total of 20 radio stations in the
free end of the cable may still be live if only thememory (20 FM and 20 MW), manually or
connector is removed from the MAINS socket atautomatically (Autostore).
the back of the unit. Manual programming
The type plate is located on the bottom of the1 Tune to your desired station (see Tuning to radio
set.stations).
2 Press PROG to activate programming.
Helpful hints:? Display: PROG flashes.
? To avoid unnecessary energy consumption, always3 Press -, + ( PRESET+,? on the remote control)
adjust the Source selector to OFF after usingonce or more to allocate a number from 1 to 20.
the set.
4 Press PROG to confirm.
5 Repeat steps 1-4 to store other stations.
BASIC FUNCTIONS
Helpful hints: You can erase a preset station by
Switching on and off and selecting functionstoring another frequency in its place.
1 To switch on, adjust the Source selector to
CD/USB, MW or FM as desired.Autostore
? To switch between CD and USB mode, first adjustAutostore automatically starts programming radio
Source selector to CD/USB position, then pressstations from preset 1. Any previous presets e.g.
CD/USB button once or more. manually programmed will be erased.
2 To switch off, adjust the Source selector to OFF.1 Select MW or FM.
Adjusting volume and sound 2 Press and hold PROG until displays.
1. Adjust the volume with the VOL 3, 4 or DBB ( on? Available stations are programmed (MW or FM).
the remote control). After all stations are stored, the last autostore
? Display shows and the volume level inpreset station will then automatically play.
number from 00-32.
To listen to a preset or autostore station
DIGITAL TUNER Press the ALBUM/PRESET -, + (on the remote
Tuning to radio stationscontrol PRESET+,?) buttons once or more until the
1 Push the source selector to MW or FM.desired preset station is displayed.
The radio station frequency, waveband and a
preset number (if programmed) are shown.
(See 2) |
ACEC
