TROUBLESHOOTING
WARNING
Do not open the set as there is a risk of electric shock! Under no circumstances should you try to
repair the set yourself, as this will invalidate the guarantee.
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
Remote control does not function properly Note:
? Batteries exhausted/ incorrectly insertedMake sure the CD is not encoded with
Copyright protection technologies, as some do
? Insert (fresh) batteries correctly
? Distance/ angle between the set too largenot conform to the Compact Disc standard.
? Reduce the distance/ angleThe disc skips tracks
No sound /power? Disc damaged or dirty
? Volume not adjusted? Replace or clean disc
? Adjust the VOLUME? SHUF orPROG is active
? Power cord not securely connected? Switch off SHUF/PROG
? Connect the AC power cord properlyNote:
? Batteries dead/ incorrectly insertedDRM-protected WMA is not supported.
? Insert (fresh) batteries correctly
Sound skips during MP3 playback
Severe radio hum or noise? MP3 file made at compression level exceeding
? Electrical interference: set too close to TV, VCR or320kbps
computer? Use a lower compression level to record CD
? Increase the distancetracks into MP3 format
Poor radio reception? Disc damaged or dirty
? Replace or clean disc
? Weak radio signal
? FM: Adjust the FM telescopic aerialThe USB device doesnt play on my AZ1826.
? It is not set in the USB mode.
indication
? Press CD/USB to select USB mode.
? It is set in the USB mode. ? The device is not securely connected to AZ1826s USB
? Press CD/USB to select CD mode.
port.
? CD badly scratched or dirty? Re-connect the device, and make sure that the device
? Replace/ clean CD, see Maintenanceis powered on.
? Laser lens steamed up? The device is not supported by AZ1826, or the audio
? Wait until lens has clearedfile format stored on the device is not supported by
? CD-R/CD-RW is blank/ not finalizedAZ1826.
? Use a finalized CD-R(W)? Use a compatible device/ playable audio file format.
? CD-ROM disc inserted/
CD contains non-audio filesI cannot use the remote control to select CD or
? Use CD Audio discs/MP3-CD only/ USB.
press or once or more to skip to a CD audio? The main unit is not set in CD/USB mode
track instead of the data files ? On the main unit, push Source selector to CD/USB
position, then use the remote control to select CD or
USB. |
ACEC
