P001-020_AZ5130-00 Eng 11/15/03 10:27 PM Page 20
AZ 5130 page 20
TROUBLESHOOTING
EnglishIf a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
ProblemSolution
CD/VCD OPERATION
"NO DISC" is displayed� Insert a disc.
� Check if the disc is inserted upside down.
� Wait until the moisture condensation at the lens has
cleared.
� Replace or clean the disc, see "Maintenance"
� Use a readable disc or correct recorded format
MP3-CD.
No picture on TV screen� Connect the cable between the system and TV.
No colour on TV� Change the system to the respective PAL or
NTSC setting.
RADIO RECEPTION
Radio reception is poor� If the signal is too weak, adjust the antenna
for better reception.
� Increase the distance between the Receiver
and your TV or VCR.
TAPE OPERATION/RECORDING
Recording or playback cannot be made� Clean deck parts, see "Maintenance".
� Use only NORMAL (IEC I) tape.
� Apply a piece of adhesive tape over the missing
tab space.
GENERAL
The system does not react when buttons � Slide the source sector to TAPE/OFF. Remove and
pressed/set does not work/no display onreconnect the AC power plug for 30 seconds and
LCD.switch on the set again.
Sound cannot be heard or is of poor� Adjust the volume.
quality� Make sure the MP3-CD was recorded within
32-320 kbps (128kbps preferably) with sampling
frequencies at 8 - 48 kHz (44.1kHz preferably).
The remote control does not function� Reduce the distance between the remote control
properlyand the system.
� Insert the batteries with their polarities (+/- signs)
aligned as indicated.
� Replace the batteries.
� Point the remote control in the direction of the
system's IR sensor.
20 |
ACEC
