CCZ092comb.QX33 4/5/99 6:06 PM Page 33
Timer Recording (contOd) 33
4
Use the Number buttons (1 - 8) to select a position in
which to store the timer recording. Flashing numbers indi-
4-7
cate an open position (one in which a timer recording has not yet
been stored).
NOTE: If you select a number that has already been used to store a
timer recording, PREVIOUSLYSETPROGRAM will appear on-screen for
POWERSLEEP
a few seconds. Then information about the program in that position
ALT.CH
will appear on-screen. If this happens, press the STATUS/EXIT button.23
1
Then use the Number buttons to select another position.
456o
CHANNEL
789p
5
0+100o
lIf you are using an antenna or cable connection, enter the chan-SPEEDMUTEVOLUME
p
nel of the TV program you want to record (you must enter a 0o
before all single-digit channels).PLAY
lIf you are recording from line input, press 0, 0. A/V INwillREWF.FWD
STOP
appear on-screen.
p
lIf you are recording using a Cable Box, enter the Cable BoxREC/OTRMEMORYPAUSE/STILL
o
output channel (03 or 04). Be sure to select the channel of theMENUSTATUS/EXITCLEARTRACKING
p
TV program at the Cable Box and leave the Cable Box on for
the timer recording.
ONE TIME PROGRAM
PROGRAM 1
CHANNEL � �
TO CORRECT PRESS CLEAR
TO END PRESS EXIT
6
Press two Number buttons for the hour(s) you want the
recording to begin. Press two Number buttons for the
minute(s) you want the recording to begin. Press 1 for
AM or 2 for PM. For example, for 9:30 PM, press 09, 30, 2.
ONE TIME PROGRAM
PROGRAM 1
CHANNEL 10
TIME ON � � : � �
TO CORRECT PRESS CLEAR
TO END PRESS EXIT
Helpful Hints
7Y If the numbers entered do not
Follow the instructions in step 6 to set the recordingOsmatch the TV/VCROs calendar, the
stop time. (AM or PM will be set automatically.)entry will be rejected and a question
mark will appear on screen.
ONE TIME PROGRAM
PROGRAM 1Y To make corrections while you are
programming a timer recording,
CHANNEL 10
TIME ON 09:30 PMpress the CLEAR button until the
TIME OFF � � : � �
cursor is flashing on the item you
TO CORRECT PRESS CLEARwant to change. Then enter the cor-
TO END PRESS EXIT
rect information.
Instructions continue on page 34. |
ACEC
