CCZ252comb.QX33 4/6/99 8:50 PM Page 8
8 Turning On the TV/VCR
Before you turn on the TV/VCR, make sure there are batteries in
the remote control and the TV/VCR is hooked up correctly.
The instructions on this page work only when you turn on the
1
TV/VCR for the first time.POWERSLEEP
ALT.CH
123
12456o
CHANNEL
Press the POWER button. The TV/VCR will come on and the
789p
screen shown below will appear.
0+100o
5
VOLUME
SELECT LANGUAGESPEEDMUTE
p
1 ENGLISH ONo
PLAY
2 ESPA?OL
REWF.FWD
MAKE SELECTION ORSTOP4
PRESS EXIT TO CONTINUE
p
REC/OTRMEMORYPAUSE/STILL
o
MENUSTATUS/EXITCLEARTRACKING
p
2
Press the Number 1 button to select English on-screen3
displays or press the Number 2 button to select Spanish
on-screen displays.
3
Press the STATUS/EXIT button. The screen shown below
will appear.
CONNECT ANTENNA OR CABLE
TO TVCR
THEN PRESS B
Helpful Hints
TO END PRESS EXIT
Y If you do not see any on-screen dis-
plays when you turn on the TV/VCR,
check your hookups, then try again.
4
If you still do not see any on-screen
Press the F.FWD/ B button to begin automatic channel
displays, follow the steps on pages
setup. The TV/VCR will memorize all available channels. Whennine - 10 to select a language and
channels are set, CHANNELS ARE SET will appear on-screen
set up channels.
briefly. Then the TV/VCR will go to the lowest channel pro-
Y To skip step 2, press the
grammed.
STATUS/EXIT button. All on-screen
displays will be inEnglish. To skip
step 4, press the STATUS/EXITbut-
5ton. Channels will not be set up,
Use the CHANNEL o/p buttons or the Number buttonsand CHANNELS NOT SET will
on the remote control to select a TV/VCR channel. Useappear on-screen briefly.
the VOLUME o/p buttons to adjust the sound.
Y You cannot set up channels if you
are using a Cable Box.
Y Line Input mode will always be
stored in the TV/VCROs memory as
channel 00. When you select chan-
nel 00, A/V IN will appear on-
screen briefly. Press the CHANNEL
o/p buttons or Number buttons to
select another channel. |
ACEC
