CCZ254comb.QX33 4/6/99 9:01 PM Page 10
10 Automatic Channel Setup
Although the TV/VCR may automatically memorize the channels
you receive when you turn it on for the first time, you may set upWait for the TV/VCR to set up
channels again by following the steps below.channels.
5
1
Press the COMBI button, then press the MENU button.
POWEREJECT
SLEEPSPEEDMEMORY
>PRIM. SETUPPRESS B
VCR PROGRAM
VCR SETUPREC/OTRPAUSE/STILL
CAPTION
REMINDER
BRIGHTNESSPLAY2
REWF.FWD
STOP3
MENUSTATUS/EXITCLEAR
2
1
Press the PLAY/s button or the STOP/t button to select4
123
INPUT. Press the REW(ind)/s button or the F.FWD/B
CH.
button until ANTENNA or CABLE (whichever you have)456
appears beside INPUT.789
TO ADJUST PRESS s /BA.CH0+100
VOL.
CABLE/DBSCOMBI
>INPUTCABLE
EXITVCR PLUS+
PRIM. SETUPVAR.SLOW/ENTERMUTE
VCR PROGRAM
VCR SETUPTRACKINGF.ADVSLOW
CAPTION
PICTURESMARTSEARCHSKIP SEARCHINDEX
3
Press the STOP/t button repeatedly to select PRIM.
SETUP, then press the F.FWD/B button.
PRIMARY SETUP
1 SELECT LANGUAGE
2 AUTO PROGRAMMING
3 ADD/DELETE CHANNEL
4 CH. MEMORY REVIEW
5 VOLUME BAR[ON]
6 SET CLOCK
7 REMOTE LOCATOR
TO SELECT PRESS NUMBER
TO END PRESS EXIT
4
Press the Number 2 button to select AUTO PROGRAM-Helpful Hints
MING. AUTO PROGRAMMING MEMORIZED CH... will appear
on-screen. The TV/VCR will memorize all available channels.Y Line Input mode will always be
stored in the TV/VCROs memory as
channel 00. You cannot delete it. To
5exit line input mode, press the
Wait for a few minutes. When setup is complete, CHANNELSCH(annel). Up/Down buttons or the
ARE SET will appear on-screen. Then the programming of theNumber buttons to select another
lowest channel number placed in the TV/VCROs memory willchannel.
appear on-screen. Now, when you press the CH(annel). Up/DownY You cannot program channels when
buttons, you will scan only through channels you receive.the TV/VCR is on channel 00 (A/V
INPUT will appear beside INPUT at
step 2). Select ANTENNA or CABLE
at step 2. |
ACEC
