FIXING PROBLEMS
English20 second pause between recordings
" see synchronized digital recording (CD-SYNC) p. 8Troubleshooting
If you think your CD recorder is defective, it is wise to checkPlayer does not react
this list first and run the diagnostic program. Maybe you have" switch the ON/OFF button on the front of the
forgotten a simple step.player off and back then on
Warning!SERVICE on display after switching on
Under no circumstances should you attempt to repair"try switching off and on again
the CD recorder yourself as this will invalidate the
guarantee.
RECOVER on display
" a power failure has occurred during recording;
SYMPTOM: " SOLUTION:the CD recorder is attempting to repair the
disc.
No power " check to ensure that the ON/OFF button is on" if RC-DISC then appears on the display,
" check to ensure that the power cable isthe disc cannot be recorded further, and
plugged in correctly
" switch the recorder OFF and then immediatelycannot be finalized. However, it can be played
on a CD recorder.
back ON" on a CD-RW disc, the track being recorded is
lost, but further recording and finalization can
Auto track does not work
" check to ensure that auto track is selected.still be done.
" check to ensure that there are 3 seconds" if OPC FAIL appears, no further recording
is possible. You can still use the disc as a CD
silence in between the tracks (analogueon this recorder.
recording only)
" check to ensure that the source is a consumer
source with the digital output according the
IEC audio standard.Diagnostic program
No sound " check the audio connectionsIf the malfunction continues, perform the Diagnostic Program:
" if using an amplifier, try using a different
source
1 Switch the recorder off using ON/OFF.
Amplifier sound is distorted
" check to ensure that the CD recorder analogue2 Simultaneously press PLAY and STOP and switch the
output is not connected to the amplifier Phonorecorder back on using ON/OFF.
input.� The display will now indicate BUSY and after a few
minutes, the message will change to ERROR or
Play will not startPASSED
" check to ensure that the label of the CD is
facing up" If the ERROR message appears, your recorder is
" clean the discdefective and needs to be repaired. Consult your supplier
" check to ensure that the disc is not defectiveor call the Philips Consumer Line to find the nearest
by trying another discservice center. The number of the Consumer Line can be
found in the guarantee booklet.
Remote control does not work
" point the remote control directly at the CD
" If the PASSED message appears, you may be
recordermisinterpreting the user instructions or using an
" check the batteries and replace if necessary
" select the right source firstinappropriate disc, or there may be a mechanical defect or
an incorrect connection. Carefully read the user
Will not recordinstructions once again; and if necessary contact your
supplier.
" clean the disc.
" check to ensure that CD-RW is not finalized
" check to ensure that the disc is recordable and" If you cannot solve the problem, contact to the nearest
service center.
replace if necessary
" the disc is not an AUDIO disc
" wrong input source selected.3 Switch off the recorder using ON/OFF to exit from the
Diagnostic Program.
Analog recording is distorted
" make sure the recording level is correct
18 |
ACEC
