RECORDING
EnglishAfter recording the display will show UPDATE for several
Analogue recording
seconds.
Note:PLAY
PAUSESTOPOPEN/CLOSE
- The CD recorder will not start until it recognizes a digital
RECORDFINALIZREC LEVEL
signal. Although the reaction time is less than 2004567
38
milliseconds, the very beginning of the music maySOURCEAUTO/MANAL29
CD-RECORDABLE/REW110
sometimes not be recorded. If this happens, you can startRITABLE 020
50
the recording manually (see digital recording-Power On/Off
unsynchronized).DIRREECCOT LRDINEING
Phones
- Recordings from DAT or DCC will only stop after 20 silence.
Only make analogue recordings if digital recording is not
possible.
Preparing for analogue recording
1 Make sure the disc is absolutely free of scratches and dust
particles.
2 Press Source repeatedly until:
�ANALOG appears on the display.
DIG AUTO TRACK REPEAT 1TOTAL REMTRACK TIME
ANALOG
PROG
3 Press AUTO/MANUAL to switch between auto and manual
track numbering.
� If Auto is selected (preferred), AUTOTRACK appears on
the display.
" AUTO: The track number is automatically incremented after
a silence on the original of at least 3 seconds.
" MANUAL: Track numbers can be incremented manually by
pressing §. (minimum track length is 4 seconds ).
(This can also be done in AUTO mode)
" Track numbers cannot be changed after recording.
4 With the recorder stopped, press RECORD to enter Record
standby mode.
�RECORD will flash
DIG AUTO TRACK REPEAT 1TOTAL REMTRACK TIMECD SYNC
RECORD
FINALIZE
GERASE
5 Play the source first to set the optimal recording level on
the CD recorder.
6 Adjust the REC LEVEL until all blue segments on the
Record/Play Level bar light up but no red segments light
continuously during the loudest passages.
7 Stop the source.
14 |
ACEC
