Important Note
DKS
Advarsel:Klass 1 laserapparat
Laserrudstrling ved bning nr sikkerhesafbrydere er ude afVarning!
funktion. Undg u tsttelse for strling.Om apparaten anvnds p annat stt n i denna bruksanvisning
specificerats, kann anvndaren utsttas fr laserstrlning, som
Bemrk:versjruder grnsen fr lserklass 1.
Netafbryderen POWER er sekundrt indkoblet og afbryder ikke
strmmen fra nette. Den indbyggede netdel er derfor tilsluttet tilObservera!
lysnettet s lnge netstikket sidder i stikkontakten.Strmbrytaren POWER r sekundrt kopplad och inte bryter
strmmen fran ntet Den inbyggda ntdelen r drfr ansluten till
elntet s lnge stickproppen sitter i v gguttaget.
NSF
Observer:Luokan 1 laserlaite + Klass 1 laserapparat
Nettbryteren POWER er sekundert innkoplet. DenVaroitus!
innebygdenetdelen er derfor ikke frakoplet nettet s lenge apparatetLaitteen kyttminen muulla kuin tss kyttohjeessa mainitulla
er tilsluttet nettkontakten.tavalla saattaa altistaa kyttjn turvallisuusluokan 1 ylittvlle
lasersleilille.
Huom.
Toiminnanvalitsin POWER on kytketty toisiopuolelle, eik se kytke
laitetta irti shkverkosta. Sisnrakennettu verkko-osa on
kytkettyn shkverkkoon aina silloin, kun pistoke on pistorasiassa.
Important Note for Users in the UK
Mains plugHow to connect a plug
This apparatus is fitted with an approved 13 Amp plug.ToThe wires in the mains lead are coloured with the following
change a fuse in this type of plug proceed as follows:code: blue = neutral (N), brown = live (L).
1 Remove fuse cover and fuse.As these colours may not correspond with the colour
2 Fix new fuse which should be a BS1362 5 Amp,markings identifying the terminals in your plug, proceed as
A.S.T.A. or BSI approved type.follows:
3 Refit the fuse cover.Y Connect the blue wire to the terminal marked N or
coloured black.
If the fitted plug is not suitable for your socket outlets, it shouldY Connect the brown wire to the terminal marked L
be cut off and an appropriate plug fitted in its place.or coloured red.
If the mains plug contains a fuse, this should have a value of 5Y Do not connect either wire to the earth terminal in
Amp. If a plug without a fuse is used, the fuse at thethe plug, marked E (or e) or coloured green
distribution board should not be greater than 5 Amp.(or green and yellow).
Before replacing the plug cover, make certain that the cord grip
Note:The severed plug must be disposed of to avoid a possibleis clamped over the sheath of the lead - not simply over the
shock hazard should it be inserted into a 13 Amp socket
two wires.
elsewhere.
Copyright in the U.K.
Recording and playback of material may require
consent. See Copyright Act 1956 and The PerformerOs
Protection Acts 1958 to 1972.
2IMPORTANT NOTE |
ACEC
