NTSC/PAL SettingsGeneral Explanation
You can switch the NTSC/PAL setting of the DVD player to
match the video signal of your TV. This setting only affectsAbout this manual
the televisionOs on-screen display that shows the stop and
This manual gives the basic instructions for operating the
setup modes. You may select either NTSC or PAL. To
DVD player. Some DVDs require specific operation or
change the DVD player setting to PAL or NTSC, follow the
allow only limited operation during playback. When this
steps below.
occurs, the symbol ? appears on the TV screen, indicating
that the operation is not permitted by the player or the
1Unplug the DVD player from the mains.
disc.
2Press and hold 9 and T , on the front of the DVD
player. While holding 9 and T , plug in the mains.
Remote control operation
3After PAL or NTSC appears on the display of the DVD
player, release 9 and T at the same time. The PAL or? Unless stated, all operations can be performed by the
NTSC indicator that appears on the display indicates theremote control. Always point the remote control directly at
current setting.the player, making sure there are no obstructions between
4To change the setting, press T within three seconds. Thethe remote and the player.
new setting (PAL or NTSC) will appear on the display.Corresponding keys on the front panel of the player can
also be used.
NTSC/PAL ConversionMenu bar operation
This player is equipped with a NTSC/PAL conversion? A number of operations can be done with the menu bar
feature to convert the video output of the disc to matchon the screen. The menu bar icons can be accessed by
your TV system. The conversions supported are as below:pressing the cursor keys on the remote control.
? Pressing SYSTEM MENU while the menu bar is displayed
DiscOutput format
will clear the menu bar from the screen.
TypeFormatSelected mode
NTSCPALAUTO? The selected item will be highlighted, and the appropriate
DVDNTSCNTSCPALNTSCcursor keys to operate it will be displayed below the icon.
Not
PALSupportedPALPAL? The symbols < or > indicate more items are available at
VCDNTSCNTSCPALNTSCthe left/right of the menu bar. Press 1 or 2 to select these
PALNTSCPALPALitems.
1In the Preference Menu, select TV System.
2Press 3 or 4 to select PAL, NTSC or AUTO.
Notes:
� AUTO can only be selected when using a TV that has both
the NTSC and PAL systems.
� This is applicable for CVBS output on cinch and SCART only
� Slight picture distortions may occur due to this conversion.
This is normal. Thus, the AUTO format is most suitable for the
best picture quality.
10PREPARATION |
ACEC
