Getting Started
EnglishStep 1: Inserting batteries intoStep 2: Setting up the TV
the Remote Control
IMPORTANT!
3Make sure you have completed all
the necessary connections. (See
1pages 9-10 OConnecting TV�).
2
1Turn on the TV and set to the correct
video-in channel. You should see the DVD
background screen on the TV.
1Open the battery compartment.
2Usually these channels are between the
2Insert two batteries type R06 or AA,lowest and highest channels and may be
following the indications (+-) insidecalled FRONT, A/V IN, or VIDEO. See your
the compartment.TV manual for more details.
3Close the cover.� Or, you may go to channel 1 on your
TV, then press the Channel down button
repeatedly until you see the Video In
channel.
Using the Remote Control to� Or, the TV Remote Control may have a
operate the Player
button or switch that chooses different
1Aim the Remotevideo modes.
Control directly at the� Or, set the TV to channel 3 or 4 if you
remote sensor (IR) onare using an RF modulator.
the front panel.3If you are using external equipment, (eg.
2Do not put any objectsaudio system or receiver), turn it on and
between the Remoteselect the appropriate input source for
the DVD Player output. Refer to the
Control and the DVD
Player while operatingequipment ownerOs manual for detail.
the DVD Player.
PREVIEW MUTE
CAUTION!
� Remove batteries if they are
exhausted or if the Remote Control
is not being used for a long time.
� Do not use old and new or
different types of batteries in
combination.
� Batteries contain chemical
substances, so they should be
disposed properly.
14
3139 246 15791 |
ACEC
