Getting Started
EnglishStep 1: Inserting batteries intoStep 2: Setting up the TV
the Remote ControlIMPORTANT!
Make sure you have completed all
the necessary connections. (See
pages 9-10 OConnecting TV�).
1Turn on the TV and set to the correct
video-in channel. You should see the DVD
background screen on the TV.
2Usually these channels are between the
lowest and highest channels and may be
1Open the battery compartment.called FRONT, A/V IN, or VIDEO. See your
TV manual for more details.
2Insert two batteries type R03 or AAA,� Or, you may go to channel 1 on your
following the indications (+-) insideTV, then press the Channel down button
the compartment.repeatedly until you see the Video In
channel.
3Close the cover.� Or, the TV Remote Control may have a
button or switch that chooses different
Using the Remote Control tovideo modes.
operate the Player� Or, set the TV to channel 3 or 4 if you
are using an RF modulator.
1Aim the Remote Control3If you are using external equipment, (e.g..
directly at the remote
sensor (IR) on the frontaudio system or receiver), turn it on and
panel.select the appropriate input source for
the DVD player output. Refer to the
2Do not put any objectsequipment ownerOs manual for detail.
between the Remote
Control and the DVD
player while operating the
DVD player.
CAUTION!
� Remove batteries if they are
exhausted or if the Remote Control
is not being used for a long time.
� Do not use old and new or
different types of batteries in
combination.
� Batteries contain chemical
substances, so they should be
disposed properly.
14 |
ACEC
