PLAYING A CDPLAYING A CD
With this set you can play
7Press and hold 2; 2-3 secondsto seconds again to
� all pre-recorded audio CDs (CDDA)
switch off the CD player.
� all finalized audio CDRs and CDRWs
� WMA/MP3-CDs (CD-ROMs with WMA/MP3 files)8To remove the disc, hold it by its edge and press the
hub gently while lifting the disc.
1Push the open YYçYYslider to open the CD lid.
0
2Insert a disc, printed side up, by pressing gently on the
disc?s center so that it fits onto the hub. Close the lidHelpful Hint:
by pressing it down.
� After pressing 2; it may take some time until the first MP3/WMA track is
3Press and hold 2;briefly to start playback.played.
� Display shows EXPANIUM. "Reading CD" will be� By default, playback begins from the exact point when last switched off.
displayed only if the reading time exceed 2 sec� If a CD-Recordable (CD-R) or a CD-Rewritable (CD-RW) is not recorded
(MP3/WMA). For CD Audio, the current track num-properly, Unfinalized CD is displayed, indicating that the CD has not been
ber is displayed. For an MP3/WMA track, file name is displayed.finalized. In that case, use FINALIZE on your CD recorder to complete the
4Press 2;briefly to interrupt playback.recording.
� The time where playback was interrupted blinks.� When playing a CD, please note that it can take 3-5 seconds after pressing
2; for sound reproduction to start.
5To resume playback press 2;briefly again for MP3/� Playback will stop if you open the CD lid.
WMA CDs.� While the CD is paused, the elapsed play time flashes in the display.
� Display shows your selected display mode, or [Filename]
6Press and hold 2; 2-3 seconds to stop playback.
� The total number of tracks, the track
types (CD, WMA,MP3), the number of albums on an
WMA/MP3-CD and the total playing time (of an
audio disc only) are displayed.
VOLUME, BEEP, DBB SELECTING A TRACK AND SEARCHING
VOLUMESelecting and searching on all discs
Volume adjustmentSelecting a track during playback
Y Adjust the volume by pressing VOLUME+/�Y Briefly press or § once or several times to skip to the
(up or down).beginning of the current, previous or subsequent track.
� Playback continues with the selected track.
DBBSearching for a passage during playback
Bass adjustment (remote control only)1Keep or §pressed to find a particular passage in backward or forward direc-
tion.
1Press DBBonce or more to select the bass enhance-� Searching starts and playback continues at a low volume.
ment options:For CD audio tracks the search speeds up after 2 seconds.
�moderate bass enhancement is activated.
2Release the button at the desired passage.
�strong bass enhancement is activated.� Normal playback continues.
2Press DBBagain to switch off the bass enhancement options.
Helpful Hint:During searching is only possible within the current
�or disappears.
track.
Selecting on WMA/MP3-CDs
BEEPSelecting an album during playback
Acoustic feedback (remote control only)Y On the remote control, briefly press ALBUM + / � once
or several times to skip to the first track of the current,
Acoustic feedback is a beep signal that is heard whenprevious or subsequent album.
buttons on the set or remote control are pressed. Also,� The first track of the selected album is played.
when the set or remote control is in pause mode or the
battery power is low, it beeps at intervals.Selecting a track during playback
1Keep DBBpressed for 2 seconds to switch the beep either on or off:
1Keep ALBUM +/ �pressed to skip quickly to previous or subsequent MP3
� Beep on is displayed: Beep is switched on.tracks.
� Beep off is displayed: Beep is switched off.� Skipping starts and speeds up after 5 seconds.
2Release the button at the desired track.
� Playback continues with the selected track.
Helpful Hint:To skip from track to track at low speed, use or §. |
ACEC
