ENGLISH7
Reach & Clean nozzle (specific types only)
� The Reach & Clean nozzle can be used on either carpets or hard floors.The nozzle can be
turned 360 degrees to 4 different positions, allowing you to also vacuum clean hard-to-reach
places in an easy way.When the nozzle is positioned lengthwise, the suction power is
concentrated at the front side of the nozzle (fig. 6).
� To adjust the nozzle to the type of floor and the area to be cleaned, put your foot on one of
the indicated spots and then turn the tube until the nozzle is in the required position (fig. 7).
1 With the nozzle positioned breadthwise and the brush strip folded out, you can clean large
hard floor areas.Turn the nozzle until the brush strip pops out of the nozzle housing and the
nozzle is positioned breadthwise (fig. 8).
2 With the nozzle positioned lengthwise and the brush strip folded out, you can vacuum clean
small hard floor areas.Turn the tube 90 degrees anticlockwise until it is positioned lengthwise
with the brush strip still folded out of the nozzle housing (fig. 9).
3 With the nozzle positioned breadthwise and the brush strip folded in, you can vacuum clean
large soft floor areas.Turn the tube 90 degrees anticlockwise again to position the nozzle
breadthwise and to make the brush strip disappear into the nozzle housing (fig. 10).
4 With the nozzle positioned lengthwise and the brush strip folded in, you can vacuum clean
small soft floor areas.Turn the tube 90 degrees anticlockwise again until the nozzle is
positioned lengthwise with the brush strip still folded in (fig. 11).
Convertible nozzle (specific types only)
� The convertible nozzle can be used on either carpets or hard floors.
1 Push the rocker switch on top of the convertible nozzle with your foot to make the brush
strip for cleaning hard floors come out of the nozzle housing (fig. 12).
2 Push the rocker switch again to make brush strip disappear into the convertible nozzle
housing again (fig. 13).
Crevice tool, small nozzle and small brush (specific types only)
1 Connect the crevice tool, small nozzle or small brush directly to the handgrip or to the tube
(fig. 14).
Accessory clip
� The accessory clip can simply be snapped onto the tube (fig. 15).
� The crevice tool and the small nozzle can be snapped onto the clip.
Using the appliance
1 Pull the cord out of the appliance and put the mains plug in the wall socket.
2 Switch the appliance on by pressing the on/off button on top of the appliance with your foot
(fig. 16).
� During vacuum cleaning you can adjust the suction power by means of the knob on top of
the appliance (fig. 17).
- Use maximum suction power for vacuum cleaning very dirty carpets and hard floors.
- Use minimum suction power for vacuum cleaning curtains, table carpets, etc.
� If you want to pause for a moment, you can park the tube in a convenient position by
inserting the ridge on the nozzle into the parking slot (fig. 18). |