8English
Infrared remote control (specic types only)
1 Remove the lid of the battery compartment (1) and insert two AAA 1.5-volt batteries (2).
Reattach the lid of the battery compartment (3). (Fig. 14)
Make sure that the - and + poles point in the right direction.
using the appliance
1 Pull the cord out of the appliance and put the mains plug in the wall socket.
2 Press the on/off button on top of the appliance to switch on the appliance. (Fig. 15)
adjusting suction power
, During vacuum cleaning, you can adjust the suction power to one of 5 different settings with
the MIN and MAX buttons on top of the appliance. (Fig. 16)
, If your appliance is equipped with an infrared remote control (specic types only) you can set
the suction power to one of 5 different settings with the and + buttons on the infrared
remote contr (Fig.ol. 17)
- The blue suction power lights show the selected suction power level.
- Use maximum suction power to vacuum very dirty carpets and hard oors.
- Use minimum suction power to vacuum curtains, table carpets, etc.
, When you switch on the appliance, it starts running at the last selected suction power
setting. If your appliance is equipped with an infrared remote control (specic types only) it
starts running at the highest suction power. (Fig. 15)
pausing during use
1 If you want to pause for a moment, park the tube in a convenient position by inserting the
ridge on the nozzle into the parking slot. (Fig. 18)
2 If your appliance is equipped with an infrared remote contr press the ol (specic types only),
standby button to temporarily switch the vacuum cleaner off, for instance when you have to
move some furniture. (Fig. 19)
, The middle suction power light starts burning to indicate that the vacuum cleaner is in
standby mode.
3 To continue vacuum cleaning, simply press the standby button, - or + button.
using the Filter-Clean button
A clean lter cylinder helps maintain high suction power.
Always press the Filter-Clean button when you have nished vacuum cleaning.
The lter-cleaning process only needs to be performed once to guarantee proper cleaning of the
lter.
1 Switch off the appliance and leave the mains plug in the wall socket during the lter-cleaning
process.
2 Keep the appliance in horizontal position, with all wheels touching the oor.
Always leave the hose connected to the appliance during the lter-cleaning process to prevent
dust from being blown out of the appliance.
3 Press the Filter-Clean button. (Fig. 20)
, The light in the Filter-Clean button goes on and you hear a beep before the lter-cleaning
process starts. |
ACEC
