SYSTEM SETUP
Speaker setup and testingPower handling
The relative volume of the speakers must be adjusted forIf the receiver is used at very high power it can produce
optimal surround sound. You should be at your usual listeningdistortions which may damage your speakers seriously. If
position when adjusting the speaker volume. See OReceiverdistortions occur, reduce the volume and the tone controls toEnglish
menus� on how to unit up the receiver for the used speakers.a level where the sound is acceptable again.
Ideally, the volume in the listening position should be the
same from all speakers.To avoid overheating of the unit a safety circuit has
been built in. Therefore your set may disconnect under
1 Press POWER / STANDBY to switch on the receiver.extreme conditions. If this happens, switch the unit off
and let it cool down before reusing it.
2 Press TEST TONE on the remote control.
yA test tone coming from the different speakers, exceptHeadphones
the subwoofer, is heard.Connecting headphones to PHONES will switch off the
speakers. The receiver switches to STEREO and surround
3 Press +/- REAR on the remote control to
increase/decrease the volume of the actual speaker. Thesound will be reduced to a stereo signal which is reproducible
best result is achieved when all speakers have equalby standard headphones.
volume in the listening position.
Disconnecting the headphones switches on the speakers
4 Press TEST TONE on the remote control.again. If you wish to enjoy surround sound again, switch the
yThe test tone stops.receiver back to surround sound.
Note: If you are not completely satisfied with the volumeMaintenance
settings, we recommend making minor adjustments to
them during surround sound playback.Clean the receiver with a soft,
slightly dampened, lint-free cloth. Do
not use any cleaning agents as they
may have a corrosive effect.
Do not expose the receiver to
humidity, rain, sand or excessive heat
(caused by heating equipment or
direct sunlight).
15 |
ACEC
