DOLBY PRO LOGIC
Y Rear (surround) speakers: ConnectCenter Speaker3 PressBALANCECENTER
Dolby Pro Logic
either the wired rear surround speakersFor the best sound, place the centerBALANCELR-+
This state of the art Dolby Pro Logic miniEnglish
or a pair of wireless rear speakers (notspeaker at the same height as the left andL to adjustREAR
system enables you to experience and
supplied) to the SURROUND OUTright speakers. Place the center speakerthe sound-+
enjoy a Home Cinema sound ambience. The
terminals.directly above or beneath the television.of the front
Pro Logic system allows more accurate
CENTERleft speaker.
definition of the individual sound sources.12 OHMRear (surround) Speakers
a The display will show BAL L+XX.
It produces greater sound separationCENTERThe surround speakers should be placed at
4 Press BALANCE R to adjust the sound
between channels and provides pinpointnormal listening ear level or mounted on
of the front right speaker.
sound localization. Pro Logic provides fourSURROUNDREARFRONTthe wall at the back of the room. Most
a The display will show BAL R
sound outputs: Left, Center, Right andimportant, experiment when placing the
REARFRONT+XX.
Surround (Rear). Front sounds are producedLEFTLEFTsurround speakers in order to obtain the
5 Press CENTER + or - to adjust the
from the pair of Left and Right speakersbest sound.
REARsound of the center speaker.
and a Center speaker. The surround soundRIGHTFRONTRIGHTa The display will show either CENT
is reproduced by two speakers placed at
Test Tone+XX or -XX.
the rear of the listening area. Although the
This feature enables you to adjust the Front6 Press REAR + or - to adjust the
surround sound is monaural (single-source),
Positioning the SpeakersLeft, Front Right, Center and Surroundsound of the surround speakers.
a pair of speakers is necessary to produce
Sound levels of the respective speakers ina The display will show either REAR
the correct diffused sound.To get the best surround sound effect,
Dolby Pro Logic mode.+XX or -XX.
place the speakers as follows.
This Pro Logic decoder enables you to7 Adjust the sound of all
You must sit at the ideal sitting
decode the following modes: DolbyCENTERSPEAKERthe speakers until they
SUB-MINI HIFIposition and use the remote control to
Surround, Center Phantom, Dolby 3FRONTLEFTWOOFERSYSTEMFRONTRIGHTare equal. When youTESTperform this operation.
UTETONE
Stereo or normal Stereo.are satisfied with the
TVCENTER
1 Press CD, TUNER, TAPE or AUX tosetting, press TEST
Setting up the Dolby Pro Logicswitch on the system.TONE again to switch
systemSURROUNDSURROUNDLEFTRIGHT2 Press TEST TONE.off the test signal.
a A test signal is generated; it will
You must set up the system properly inNote:
move through the Left, Center, Right,
order to enjoy the Home Cinema sound to� It is advisable to set the speakersO level
Front Left and Right Speakersand Surround speakers, in that order.
the fullest. First, connect the speakers.at normal listening level. "XX" denotes
For the best sound, place the Left and Righta "TEST TONE" followed by
5-Speaker Connectionspeakers at an angle of approximately 45the sound level."ADAPT BALANCE, CENTER
Y Front speakers: Connect the frontdegrees to the listener. If the speakers'AND REAR LEVEL" will be
speakers.magnetic field affects the televisiondisplayed.
Y Center speaker: Connect the centerpicture, increase the distance between thea The test signal will last for about 90
speaker.TV and the speakers.seconds.
13 |
ACEC
