PHILIPS FW-C155/37 Instruction Manual

Clock/Timer
English
1Press and hold CLOCKYTIMER for more thanActivating the timer (for the same preset
two seconds to select timer mode.
time and source)
� "12:00 AM" or "00:00" or the last timer1Press and hold CLOCKYTIMER for more than
setting starts flashing.
� starts flashing.two seconds.
2Press CD 1/2/3, TUNER or PROGRAM to2Press CLOCKYTIMER again to store.
� The last set timer information is displayed for
select the desired source.a few seconds and is shown.
� OCD1 [or 2, 3] XX:XX" indicates the CD
mode is selected.
� OTU XX:XX� indicates the Tuner mode isSleep timer setting
selected.The sleep timer enables the system to switch to
� OPROG XX:XX" indicates the CD programmestandby mode automatically at a preset time.
mode is selected.1Press SLEEP on the remote control repeatedly
 Before setting timer, make sure the music sourceto select a preset time.
has been prepared.� The selections are as follows (time in
CD 1/2/3 Load the disc(s). To start from aminutes):
specific track, make a programme (refer to CD15 " 30 " 45 " 60 " 90 " 120 "
Operation - Programming the disc tracks).OFF " 15
TUNER tune to the desired radio station.� "SLEEP XX" or "OFF" is displayed. "XX" is
3Pressa or á on the system repeatedly to setthe time in minutes.
the hour for the timer to start.2When you reach the desired length of time, stop
4Pressí or ë on the system repeatedly to setpressing the SLEEP button.
the minute for the timer to start.� is shown, except for "OFF" mode.
� The sleep timer is now set. Before the system
5Press CLOCKYTIMER to store the timer.
� "TIMER ON" is displayed, followed by the setswitches to standby mode, a countdown of 10
seconds is displayed.
timer "XX:XX" and the selected source."SLEEP 10" " "SLEEP 9".... " "SLEEP 1"
� remains on the display.
" "SLEEP"
 At the preset time, the selected source will play.
To check the remaining length of time
To exit without storing the settingafter sleep timer is activated
 Press �on the system. Press SLEEP once.
Notes:To change the preset sleep timer
� When the preset time is reached and the Press SLEEP again while the remaining sleep
selected disc tray is empty, the next available disctimer is shown.
will be selected. If all the disc trays are not� The display will show the next sleep timer
available, Tuner will be selected automatically.options.
� During timer setting, if no button is pressed
within 90 seconds, the system will exit timerTo deactivate the sleep timer
setting mode automatically. Press SLEEP repeatedly until "OFF" is displayed,
or press the STANDBY ON button.
Deactivating the timer
1Press and hold CLOCKYTIMER for more than
two seconds.
2Press � on the system to cancel the timer.
� "CANCEL" is displayed and the disappears.
24