Recording
CD Synchro Start RecordingRecording from other sources
1Load a blank tape into tape deck 2 and a disc(only on tape deck 2)
into a disc tray.1Load a blank tape into tape deck 2 with the
English2Press CD to select CD mode.open side downward.
? You can programme the tracks in the order you2Press CD, TUNER or AUX.
want them to be recorded (see Programming? Start playback of the selected source.
Tracks). If not, select the disc by pressing CD3Press RECORD to start recording.
(CD 123) and the tracks are recorded� The REC starts flashing.
according to the order on the selected disc.4Press � to stop recording.
3Press RECORD to start recording.
� The REC starts flashing.Notes:
� During recording, it is not possible to listen to
? Disc will start playback automatically.another source.
4Press � to stop recording.
Dubbing tapes (from tape deck 1 to tape
deck 2)
1Press TAPE ( TAPE 12 ) to select tape deck 2.
2Load the prerecorded tape into tape deck 1 and
a blank tape into tape deck 2 with full spool to
the left.
3Press DUBBING.
� "DUB" with "2" scrolling right will be displayed.
? Dubbing will start immediately.
� The REC starts flashing.
4Press � to stop dubbing.
Notes:
� At the end of side A, flip the tapes to side B and
repeat the procedure.
� Dubbing of tapes is only possible from tape
deck 1 to tape deck 2.
� To ensure good dubbing, use tapes of the same
length.
� You can switch to other source while dubbing.
23
3139 115 20143
pg 01-28/C200/21-Eng2329/05/2001, 10:13 AM |
ACEC
