General Information
This product complies with the radioAvoid condensation problem
interference requirements of the� The lens may cloud over when the system isEnglish
European Community.suddenly moved from cold to warm
surroundings, making it impossible to play a disc.
Refer to the type plate on the rear of theLeave the system in the warm environment until
system for identification and supplythe moisture evaporates.
ratings.
Do not block the vents
For users in the U.K.: please follow the
� In a cabinet, allows about 10cm (4 inches) of
instructions on page 2.
free space all around the system for adequate
ventilation.
Supplied accessories (page 3 � P1)
Care of discs
� Remote control and two AA batteries.�To clean a CD, wipe it in a straight line from
� MW loop antennathe centre towards the edge using a soft, lint-free
� FM wire antennacloth. A cleaning agent may damage the disc!
� Video cinch cable (yellow)�Write only on the printed side of a CDR(W)
�AC power cordand only with a soft felt-tipped pen.
� Handle the disc by its edge, do not touch the
surface.
Environmental information
Care of the cabinet
All unnecessary packaging has been omitted.� Use soft cloth slightly moistened with a mild
We have tried to make the packaging easy todetergent solution. Do not use a solution
separate into three materials: cardboard (box),containing alcohol, spirits, ammonia or abrasives.
polystyrene foam (buffer) and polyethylene
Finding a suitable location
(bags, protective foam sheet).
� Place the system on a flat, hard, and stable
Your system consists of materials which can besurface.
recycled and reused if disassembled by a
Built-in safety circuit
specialised company. Please observe the local
� Under extreme conditions, this system may
regulations regarding the disposal of packaging
switch to the standby mode automatically. If this
materials, exhausted batteries and old
happens, let the system cool down before
equipment.
reusing it.
Power saving
Care and safety information
� This system is designed to use less than 1W
(page 3 � P2)
of electricity when switched to the standby
Avoid high temperature, moisture, watermode. Disconnect the AC power cord from the
and dustpower outlet when not in use.
� Do not expose the system, batteries or discs
to humidity, rain, sand or excessive heat (caused
by heating equipment or direct sunlight). Always
keep the disc tray closed to avoid dust on the
lens.
� No objects filled with liquids, such as vases,
shall be placed on the apparatus.
� No naked flame sources, such as lighted
candles, should be placed on the apparatus.
7 |
ACEC
