Built-in CD Player
3. Press VOLUME to extend the VOLUME
Display and indicatorsoutward.
Y When you press VOLUME, it extends out-
FORM 1ward so that it becomes easier to turn. To
qwretract VOLUME, press it again.
4. Turn VOLUME to adjust the volume.
5. Press 22 or 33 to select a track.
Pressing 3 skips to the start of the next
track.
Pressing 2 once skips to the start of the cur-
er
rent track. Pressing again will skip to the
FORM 2previous track.
Y If you press and hold 2 or 3, you can per-
qwrform fast forward or reverse.
6. Press EJECT to eject the CD.
The front panel opens and the CD is ejected.
Y Be sure to close the front panel by press-
ing EJECT after removing the CD.
et
WARNING:
qSource name
Y Do not use with the front panel left open. If the
wTrack numberfront panel is left open, it may result in injury
eDisc title
in the event of an accident.
rPlay time
tTrack titleNote:
Y You can select CD as the source by pressing
SOURCE when a disc is loaded in this product.
Basic operation
Y When the front panel is open, multi-function but-
The built-in CD player plays one standard 12tons are not available.
cm or 8 cm (single) CD at a time. Do not use anY Do not insert anything other than a CD into the CD
adapter when playing an 8 cm CD. loading slot.
1. Press EJECT to open the front panel.Y A CD left partially inserted after ejection may incur
damage or fall out.
2. Insert a CD into the CD loading slot.Y If a CD cannot be inserted fully or playback fails,
make sure the recorded side is down. Press the
EJECT and check the disc for damage before rein-
serting it.
Y If the built-in CD player cannot operate properly, an
error message (such as OERROR-12�) appears on
the display. Refer to OUnderstanding built-in CD
player error messages� on page 54.
When a CD is inserted, the front panel clos-Y You can eject the CD by pressing and holding
es automatically.
EJECT with opening the front panel when the CD
loading or ejecting cannot operate properly.
15 |
ACEC
