PIONEER DVR320 Instruction Manual

DVR-04_KU.book 91 Z
8
?
?
?
??
?e
?
?xýI
Uxý9 V
?
?p
?
? 
Additional information13
"DV camcorder playback canceled.
About DV (DVR-320 only)Recording has been paused. Recording was
paused because the camcorder is not in playback
Using DV, also known as i.LINK, you can connect a DV-
equipped camcorder to this recorder using a single DV mode.
cable for input and output of audio, video, data and "Cannot operate the DV camcorder. This recorder
control signals.cannot control the camcorder. Try switching off the
camcorder then switching it back on.
The i.LINK interface is also known as IEEE 1394-1995.
i.LINK and the i.LINK logo are trademarks."Could not operate the DV camcorder. This
recorder was not able to control the camcorder.
" This recorder is only compatible with DV-format
(DVC-SD) camcorders. Digital satellite tuners and "Recording has stopped because the recorded
Digital VHS video recorders are not compatible.material on the tape finished. When the recorded
part of the DV tape comes to an end, this recorder
" You cannot connect more than one DV camcorder at automatically stops recording.
a time to this recorder.
"Recording has stopped because DV camcorder
" You cannot control this recorder from external playback stopped. Recording stopped because
equipment connected via the DV IN/OUT jack.
DV camcorder playback was stopped or the
" It may not always be possible to control the camcorder was disconnected.
connected camcorder via the DV IN/OUT jack.
"The DV camcorder is not set for playback. Please
" This recorder only outputs DVD playback video from select playback mode on the DV camcorder. The
the DV IN/OUT jack; signals from the built-in TV camcorder is in camera mode.
tuner, CD, Video CD and other inputs are not output.
" Copy-protected or copy-once video is not output from
the DV IN/OUT jack.
" Digital camcorders can usually record audio as
stereo 16-bit/48kHz, or twin stereo tracks of 12-bit/
32kHz. This recorder can only record one stereo
audio track. Set the DV Input setting as required (see
DV Input (DVR-320 only) on page 78).
" Audio output from the DV IN/OUT jack is 16-bit only.
" Audio input to the DV IN/OUT jack should be 32 or
48kHz (not 44.1kHz).
" Picture disturbance in the recording may occur if the
source component pauses playback or plays an
unrecorded section of tape, or if the power fails in the
source component, or the DV cable becomes
disconnected.
DV-related messages
You may see the following messages appear on your TV
screen when using the DV IN/OUT jack.
"No DV camcorder connected. The camcorder is
not connected properly, or the camcorder is switched
off.
"The DV camcorder is recording. The camcorder is
recording, so you cannot start recording from the
camcorder to this recorder.
"You cannot connect more than one DV
camcorder at the same time. The DV jack on this
recorder supports connection to just one camcorder.
"No tape in the DV camcorder. There is no
cassette loaded into the connected equipment.
"The DV camcorder is in record-pause mode. The
camcorder is in record-pause mode.
91
En