Operation of Remote Control (Continued)
POWERDVD/VCR
TVDVD
VCRDISPLAYINPUTPOWER
TV
POWERDISPLAY
123
REMOTE456
KEYPAD
789
FLASHBACKENTER
0100
PERSONAL PREFERENCE
ABCD
CH
VOLVOL
N+
CH
MENUMUTECHANNEL
UP (8)/
CATVTVDOWN (9)
DVDVCR
CATV/DVD-TV/VCR
REWPLAYFF
PAUSESTOPRECCH/SKIP
L HOW TO IDENTIFY A VCRSome brands have more than one remote
The remote control may already be set tocode listed, due to changes in the remote
operate your VCR. Try this initial check to seecodes from early to later model years, or due
if going on to the following Oidentify� section isto format differences (VHS/BETA). In such
necessary.cases, you may have to try more than one code
(1) Slide CATV/DVD-TV/VCR switch to VCR.to find the code your VCR accepts.
(2) Point remote towards VCR and press DVD/
Note:
VCR POWER.
(3) Does the remote turn the VCR ON and OFF?Depending on the model, year produced,
Y If yes, the remote is ready to operate the VCRbrand, and type of VCR, some models may
and no further steps are needed.not be compatible with the remote control.
Y If no, continue to the Oidentify� section.
L To Identify Your VCR � Search Method.
L To Identify Your VCR � Direct Entry Method.(1) Slide CATV/DVD-TV/VCR switch on the
Use the following steps and list to quickly findremote to VCR.
the remote control code for your accessory(2) Press POWER on the VCR to ON.
VCR.(3) Stand at least six feet away from the front of
Y First look up your VCROs remote control codethe VCR.
number before going through the direct codePoint the remote towards the VCR.
entry steps control.Hold down DISPLAY and CH UP (8) at the
Y If this procedure does not identify yoursame time. KEEP HOLDING THE BUTTONS
accessory VCR, use the Search method ofDOWN.
identification (described in the next section).(4) Watch the Channel Number indicator on the
VCR, Channel numbers will scan up when the
(1) Slide CATV/DVD-TV/VCR switch to VCR.VCR has been identified.
(2) Press and hold down DISPLAY and CH DOWNRelease DISPLAY and CH UP (8) as soon
(9) on your remote control.as the channel numbers start to scan up.
Then release both buttons.The VCROs remote control code number has
(3) Within ten seconds after releasing DISPLAYbeen identified, and the remote is ready to
and CH DOWN (9) , enter your VCROs two-operate the VCR.
digit remote control code number using
REMOTE KEYPAD (refer to list).
Y The remote control is now ready to send
commands to your VCR.
36
35-39 20R-S100.p65e3619/1/01, 5:12 PM |
ACEC
