Carrying out Network Ping Test (ADVANCED[5]Network Ping Test)
It is possible to confirm that a network connection between AN-LS1 and a computer etc. is working
normally.
advanced>5Enter O5� and press the return key.
Ping dest IP addr :192.168.150.1
Please Enter:192.168.150.152Enter IP address of device to be
(change) N> 192.168.150.152tested and press the return key.
32 bytes from 192.168.150.152: icmp_seq = 1, time = 0 ms
32 bytes from 192.168.150.152: icmp_seq = 2, time = 0 msDisplay entered IP address.
32 bytes from 192.168.150.152: icmp_seq = 3, time = 0 ms
32 bytes from 192.168.150.152: icmp_seq = 4, time = 0 msDisplay test result.
" If the return key is pressed without entering an IP address, the Ping destination IP address used
before is entered.
" If there is a fault with the connection, OError: No answer� is displayed after a 5 second retry. In
this case, please confirm the settings for AN-LS1 and the computer, and contact your network
administrator.
Setting of Accept IP Address (ADVANCED[6]Accept IP Addr(1) - [8]Accept IP Addr(3))
It is possible to improve security of AN-LS1 by allowing connection from only a prescribed IP address.
It is possible to set up to three IP addresses allowing connection to AN-LS1.
Setup
Enter O6�, O7� or O8� and press
advanced>6
Accept IP Addr(1) : 0.0.0.0the return key.
Please Enter: 192.168.150.152
(change) N> 192.168.150.152Enter numerical value and press
the return key.
Display set numerical value.
" To invalidate the Accept IP Address being currently set, enter O0.0.0.0�.
" If there is one or more Accept IP Addr being set, no connections are allowed from IP addresses
that are not yet set. They can be cancelled using [9]Accept All IP Addr.
Accepting All IP Addresses (ADVANCED[9]Accept All IP Addr)
Removes IP addresses set with OAccept IP Addr�.
advanced>9Enter O9� and press the return key.
Accept All IP Addresses(y/n)? y
Enter Oy� and press the return key.
" At the point in time where Oy� was entered, the numerical values for Accept IP Addr(1)-(3) are
reset to �0.0.0.0�.
" If On� is entered, settings are not altered.
23 |
ACEC
