ARemote SensorMBASS
When operating the remote control unit, point it towards theUse this knob to adjust the level of low frequency
REMOTE SENSOR.information.
BPOWERNSPEAKERS buttons
Press this switch to turn the unit standby or off.Use these buttons to turn on or off the speakers.
on : Sound is output from the speakers.
The equipment draws nominal non-operating power from
off : No sound is output from the speakers.
the AC outlet with its POWER switch in the OFF position.
OPHONES jack
CSTANDBY/ONFor private listening, insert the headphones plug into this jack,
and adjust the volume by turning the VOLUME knob.
When the power switch of the main unit is depressed, use
this button to turn the unit on or standby.
The standby indicator lights when the unit is in the standby
mode. When the unit is turned on, it goes off.
ENGLISH
Remote Control Unit
DINPUT SELECTORaON
Use this knob (or buttons of the remote control unit) to selectWhen the POWER switch of the main unit is depressed, use
a source.
this button to turn the unit on.
One of the indicaotrs lights to show the selected source.
ETAPE 2 MONITORbSTANDBY
When a cassette tape deck is connected to the TAPE 2 jacks,When the POWER switch of the main unit is depressed, use
use this button to turn on or off the tape monitor function.this button to turn the unit standby.
The indicator lights when the tape monitor function is on.
FMUTINGcButtons for the operation of TEACOs CD player
Use this button to mute the sound.
dButtons for the operation of TEACOs cassette tape deck
This indicator blinks during the muting.
Use these buttons to operate TEAC components with
mark.
GVOLUME
Turn this knob (or press the VOLUME buttons of the remote
control unit) to adjust the volume.
eButtons for the operation of TEAC T-R610 (TUNER).
HMIC Jack and MIC LEVEL knob
Numeric buttons:
With the microphone plugged into this jack, the sound pickedUse these buttons to select a preset channel.
up from the microphone will be heard together with the
source sound selected by the INPUT SELECTOR.
Turn the MIC LEVEL knob to adjust the input level of the
microphone.
Note:
< To simplify explanations, instructions in this manual refer to
ILOUDNESS
the names of the buttons and controls on the front panel
Use this button to compensate for the loss of bass at lowonly. Associated controls on the remote control will also
volumes.operate similarly.
JBALANCE
Use this knob to adjust the balance of the speakers.
Normally, set the knob to the center position.
KSOURCE DIRECT
Press this button to turn on or off the source direct function.
When the source direct function is set to on, the button lights
and you can listen to the sound without tone effects.
LTREBLE
Use this knob to adjust the level of high frequency
information.
7 |
ACEC
