This product has been designed and manufactured according to
WARNING: TO PREVENT FIRE OR SHOCKFDA regulations Otitle 21, CFR, chapter 1, subchapter J, based on
HAZARD, DO NOT EXPOSE THIS APPLIANCEthe Radiation Control for Health and Safety Act of 1968O, and is
TO RAIN OR MOISTURE.classified as class 1 laser product. There is not hazardous invisible
laser radiation during operation because invisible laser radiation
emitted inside of this product is completely confined in the
CAUTIONprotective housings.
< DO NOT REMOVE THE EXTERNAL CASES OR CABINETS TOThe label required in this regulation is shown `.
EXPOSE THE ELECTRONICS. NO USER SERVICEABLE PARTS
ARE WITHIN!
`For U.S.A.
< IF YOU ARE EXPERIENCING PROBLEMS WITH THIS PRODUCT,
CONTACT TEAC FOR A SERVICE REFERRAL. DO NOT USE THE
PRODUCT UNTIL IT HAS BEEN REPAIRED.
< USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY
RESULT IN HAZARDOUS RADIATION EXPOSURE.
ENGLISH
For U.S.A.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is noOptical pickup
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interferenceType: KSS213C
to radio or television reception, which can be determined byManufacturer : SONY Corporation
Laser output : Less than 0.4 mW on the objective lens
turning the equipment off and on, the user is encouraged toWavelength : 760 - 800 nm
try to correct the interference by one or more of the following
measures:
Y Reorient or relocate the equipment and/or the receiving
antenna.
Y Increase the separation between the equipment andVARING: APPARATEN INNEH?LLER LASER KOMPONENT MED
receiver.
Y Connect the equipment into an outlet on a circuit differentSTR?LNING ?VERSTIGANDE KLASS 1.
from that to which the receiver is connected.
Y Consult the dealer or an experienced radio/TV technicianOADVARSEL: USYNLIG LASERSTR?LING VED ?BNING NAR
for help.SIKKERHEDSAFBRYDERE ER UDE AF FUNKTION. UNDG?
UDSAETTELSE FOR STR?LING�
CAUTION
Changes or modifications to this equipments not expresslyOVAROITUS! SUOJAKOTELOA EI SAA AVATA. LAITE SIS?LT??
approved by TEAC CORPORATION for compliance will void theLASERDIODIN. JOKA L?HETT? (N?KYM?T?NT?) SILMILLE
VAARALLISTA LASERS?TEILY?�.
userOs warranty.
ADVARSEL: USYNLIG LASERBESTR?LING N?R DENNE DELEN ER
?PEN OG SIKKERHETSSPERREN ER UTKOBLET UNNG?
UTSETTELSE FOR STR?LING.
3 |
ACEC
