5 - Recording
Advanced recording
Fade-in and fade-out recording
At the beginning and end of recording, fade-in and 2. In recording standby mode, press the FADER key
fade-out effects can be performed. on the remote control.
1. When stopped or when in recording standby Recording begins and the sound fades in. After
mode, set the operation using the following menu the preset fade-in time, the sound is at normal
options on the REC sub-menu (see ?Operation level.
basics? on page 16).
3. During recording, press the FADER key on the
FADE IN?remote control when you wish to fade-out the
The length of the fade in to the normal level can be sound.
set between 1 and 30 seconds in 1-second increments Fade-out begins with Fade Out ashing on the
(default setting: 3 seconds).display then the unit enters recording standby
FADE OUT?mode.
The length of the fade out into complete silence can
4. Press the STOP key and the PMA writing will
be set between 1 and 30 seconds in 1-second incre-begin.
ments (default setting: 3 seconds).
The display shows Fade Out>XXs or Fade NOTE
In>XXs.Fade-in or fade-out function can be operated only
by pressing the FADER key on the remote control
unit.
Synchronized recording
Synchronized recording basically means that recording Starting playback of the source automatically starts
will begin automatically when a signal is received, and recording on the CD-RW901 if Sync function is on (see
will stop when the signal ends. ?Sync recording below) and manual record start is dis-
abled.
Use the SYNC REC key to select the synchronization
mode. The synchronization mode determines the auto-
mated start and stopping of recording when a signal is
received.
The SYNC indicator appears on the display.
Sync recording
1. While recording standby mode, press the SYNC 3. Input the source signal.
REC key. Recording begins automatically when the source
2. Set the signal detection threshold level. Use the signal is detected. The source signal should be
SYNC LEVEL option in the REC sub-menu (see higher than the adjusted threshold level.
?Operation basics? on page 16).
Rotate the MULTI JOG dial to adjust the level. levelStart of recording
The level can be set from -72 dB to -24 dB in 6
dB increments. The default setting is -24 dB.
S_LVL
Press the MENU key or push the MULTI JOG dial Noise level
to enter and return to recording standby mode.
time
NOTE
After SYNC is set, over one second of silence which
is under the adjusted threshold level is required to
start recording automatically. Otherwise, the unit
does not begin recording even if it is detecting a
signal.
TASCAM CD-RW901 27 |