6 � Effects
The DM-4800 incorporates two internal effectors: TASCAM FX2.0 and a TC Works reverb. This section dis-
cusses the setup and use of these effects.
Routing the effects
As explained in ORouting� on page 59, internal effect In the OUTPUT routing screen, the Aux sends are
inputs and outputs are treated as sources and destina-selected as outputs, and the terminal destination is
tions for routing.selected as one of the internal effects.
The two screens shown here are examples of how the Here, Aux 11 and Aux 12 are selected as aux sends to
internal routing is used with the internal effects.effect 1 (effect 2 would be set up in the same way).
For the return, the INPUT screen is used. The source is
set to EFF RTN (effect return) and channels 25 through
28 are selected as effect returns.
WARNING
Since there are no dedicated effect returns, the channels
used for returns also have aux feeds that may accidentally be
used to feed the effects being returned on that channel. If
this is done, there will be a feedback loop that may damage
your hearing, and your monitoring equipment.
Figure 6.1: Internal effect send and return routing
Setting up the effects
The EFFECT key brings up the effect screens, where for managing the other effect loop (shown in Figure
the basic setup of the internal effects is done.6.2, Effect library screen below):
First, an effect is recalled from the preset library, or
from a setting previously stored on a CF card.
When the effect setting has been recalled, it may be
used as it is, or edited using the editing screen.
After pressing the EFFECT key, pressing the POD 2
switch brings up the effect 1 library, for managing
the library effects for the Ţrst effect loop, and press-
ing the POD 4 switch brings up the effect 2 library,
Figure 6.2: Effect library screen
94 TASCAM DM-4800 UserOs Manual |
ACEC
