pg
Controls and input connections
English
A wide variety of external equipment can be connected to the input sockets on the side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the side of the television may be used for some functions.
INPUT3
(EXT 3)
Standby
GREEN � On-timer set
RED � Power On
Switching onUsing the controls and connections
If the red LED is unlit check that the mains plug isTo alter the volume press Nj+.
connected to the power supply. If the picture does not
appear press Standby on the remote control, it may takeTo alter the programme position press eeFff.
a few moments.
Press MENU and P,Q, Sor Rto control the sound
To put the television into Standby press ion the remoteand picture options.
control. To view the television press iagain. The picture
may take a few seconds to appear. Press MENU to finish.
To set up the television you will now need to use the When connecting mono sound equipment to EXT 3,
on-screen menus. Press the MENU button on the
connect the audio output of the equipmenttothe
remote control to see the menus. L/Monosocket onthe television.
The menu bar at the top of the screens will show five
different topics shown in symbols. As each symbol isTo select the Input, press Buntil the display shows
selected by pressing the Sor Rbutton on the remoteEXT3 as described on page 22. The television will
control, its respective options will appear below. automatically sense the type of signal.
To use the options press the Q button on the remotePlease always refer to the ownerOs manual of the
control to move down through them and OK, Sor Rtoequipment to be connected for full details.
select the required choice. Follow the on screen
instructions. The functions of each menu are described inPlease note: Inserting the headphone jack will mute the
detail throughout the manual.sound from all speakers.
8 |
ACEC
