Using Your Dehumidifier
Contmued
Control panel
Your dehumidifier has a control panel containing
three controls-the Fan Control, Full Pan Light
and the Humidistat.
Fan Control-This controls fan operation. It has
three modes:
l CONST FAN mode causes the fan to run at all
times while the compressor runs only to satisfy
the Humidistat setting. Use HI for faster drying.
Use LO for quieter operation.
l CYCLE FAN mode causes the fan to cycle on
and off with the compressor to satisfy the
Humidistat setting. This mode can save energy
by not running the fan constantly. Use HI for
faster drying. Use LO for quieter operation and
most energy savings.
l OFF turns the dehumidifier off until it is turned
on again.
Full Pan Light-This light glows when the water
pan is full and needs to be emptied.
Humidistat-This controls the amount of moisture
in the room. When the humidity in the room
increases, the unit automatically starts. When the
humidity decreases to the selected level, the unit
automatically stops. The unit will run constantly
at the DRYEST setting.
Unit operation
1. Turn the Fan Control to OFF. Plug power
supply cord into electrical outlet. Be sure to
use the correct grounding technique. (See
paw 4.)
2. Turn the Fan Control to the desired mode and
setting.
3. Turn the Humidistat to the desired number
setting (or DRYEST). If you need more
dehumidification, turn Humidistat to a higher
number. If you need less dehumidification,
turn Humidistat to a lower number.
NOTE: For the first few days of use, turn the
Humidistat to DRYEST. This will remove
excess moisture from the furnishings as well
as the room air.
4. Stop the unit manually by turning the Fan
Control to OFF. |
ACEC
