WASHER USE
Loading suggestions
Understanding Washer CyclesFor these suggested full-sized loads, set the LOAD SIZE selector
to the highest load size setting.
When the washer lid is closed and the Cycle Control knob is set
to a number or cycle and pulled out, the washer fills (to the
SUPER CAPACITY? PLUS WASHERS
selected load size) before agitation and timing start. The washer
begins agitating immediately after filling; agitation occurs with the
Heavy Work Clothes
washer lid down.
3 pair pants1 coverall
During agitation, the agitator creates a continuous rollover action 3 shirts1 overall
(on some models) that provides a thorough cleaning of the wash 4 pair jeans
load.
Delicates
3 camisoles2 bras
1 quilted robe2 nighties
4 slips1 baby?s dress
4 panties
Towels
10 bath towels14 washcloths
After agitation starts, the Cycle Control knob turns clockwise until
10 hand towels 1 bath mat
it points to an OFF area and the cycle ends.
NOTE: The washer pauses briefly throughout each cycle. These
Mixed Load
pauses are normal for washer operation.3 double sheets2 shirts
4 pillowcases2 blouses
WASHRINSE8 T-shirts8 handkerchiefs
6 pair shorts
1.Fill1.Fill
EXTRA LARGE CAPACITY WASHERS
Heavy Work Clothes
2 pair pants3 pair jeans
2.Wash selected 2.Rinse
3 shirts1 coverall
time
Delicates
3 camisoles2 bras
4 slips2 nighties
??
3.Drain3.Drain4 panties
No agitationNo agitation
Towels
8 bath towels10 washcloths
8 hand towels 1 bath mat
4.Spin4.Spin-Spray
rinseMixed Load
2 double sheets or6 pair shorts
1 king size sheet(s)2 shirts
4 pillowcases2 blouses
6 T-shirts6 handkerchiefs
5.Spin
Normal Sounds
Your new washer may make sounds your old one didn?t. Because
?the sounds might be unfamiliar, you may be concerned about
The Synthetics/Permanent 6.Off
Press cycle partially drains, fills, them. These sounds are normal.
agitates briefly, and drains.
During washing
When you select a small load size setting, your washer has a
lower water level. This can cause a clicking sound from the upper
part of the agitator.
LoadingDuring drain
For rated load capacity, refer to the model and serial label/plate, If water is drained quickly from your washer (depending on your
located on your washer as shown in ?Parts and Features.?installation), you may hear air being pulled through the pump
during the end of draining.
After drain and before spin
When the cycle changes from draining to spinning, you may hear
gears engaging.
5 |
ACEC
