6. Set the TEMPERATURE selector to the correct setting for the Adding bleach to models without a bleach dispenser
type of fabric and soils being washed. Use the warmest water If desired, add measured liquid chlorine bleach after the washer
safe for fabric. Follow garment label instructions.starts agitating. Pour diluted bleach around the agitator, not
Your washer uses automatic temperature control (on some directly onto the load. Undiluted bleach will damage any fabric it
models) to maintain a uniform water temperature by regulating touches. See ?Adding Liquid Chlorine Bleach.?
the incoming hot and cold water. This helps eliminate
Adding softener to models without a fabric softener
undissolved detergent and ensures consistent cleaning dispenser
results. The Hot and Warm settings on this washer will be
cooler than you are accustomed to. Wash temperatures in this If desired, add measured liquid fabric softener to the final rinse
washer are lower than the temperatures you may be used to in water. Always dilute fabric softener with 125 to 250 ml
(1 to 1 cup) of warm water. Undiluted fabric softener can stain
conventional washers.
fabrics. See ?Adding Liquid Fabric Softener.?
NOTE: Make sure that both the hot and cold water taps are
fully turned on, or the automatic temperature control feature
will not work properly. Washer Symbols
The control panel of your washer contains symbols. Refer to the
Water TempUse Forchart below for a definition of those symbols.
HotWhites and pastelsSymbolsSymbols
Heavy soils
Read InstructionsDelicates
WarmBright colors
Moderate to light soils
Small LoadHand Washables
ColdColors that bleed or fade
Light soils
NOTE: In wash water temperatures colder than 15.6oC (60°F), Large LoadSuper Wash
detergents do not dissolve well. Soils can be difficult to
remove. Some fabrics can retain wear wrinkles and have
increased pilling (the formation of small lint-like balls on the
surface of garments).ColdWash
Temperature
7. (OPTIONAL) Some models have an EXTRA RINSE selector.
For an additional rinse and spin at the end of a wash cycle, set
the EXTRA RINSE selector to ON. On some models, the Extra
WarmQuick Wash
Rinse feature is part of the cycle.
8. (OPTIONAL) Some models have an END OF CYCLE SIGNAL Temperature
selector. Set the END OF CYCLE SIGNAL selector to ON if
you want your washer to alert you when the wash cycle is
complete. The signal is helpful when you are washing items HotPrewash
Temperature
that should be removed from the washer as soon as the cycle
ends.
9. Push in the Cycle Control knob and turn it clockwise to the TemperatureRinse
wash cycle you want. Reduce the wash time when using a
small load size setting. See ?Selecting a Cycle and Time.?
OnExtra Rinse
OffSpin
Pull out the Cycle Control knob to start the washer.
To stop or restart your washer
BuzzerSlow Spin
 To stop the washer at any time, push in the Cycle Control
knob.
 To restart the washer, close the lid (if open) and pull out the
Cycle Control knob.CottonCool Down
SyntheticsPull Start
Push Stop
8 |
ACEC
