Assembling Your Tilt-Head Mixer
To Attach pouring Shield
1. Turn speed control to OFF.
2. Unplug Stand Mixer or
disconnect power.
3. Attach bowl along with flat beater,
dough hook, or wire whip. Lower
and lock motor head. To operate Speed control
Plug into a grounded 3 prong outlet.
Speed control lever should always be
set on lowest speed for starting, then
gradually moved to desired higher
speed to avoid splashing ingredients
pouring out of bowl. See page 9 for Speed
chute
Control Guide.
overload Reset
If the mixer stops due to overload,
slide the speed control lever to OFF.
4. From the front of the mixer, slide This automatically resets the mixer.
the pouring shield over the bowl Wait a few minutes. Slide the Speed
until the shield is centered. The Control Lever to the desired speed
bottom rim of the shield should fit and continue mixing. If Stand Mixer
within the bowl. does not restart see the KitchenAid
To Remove pouring ShieldStand Mixer warranty on page 14.
1. Turn speed control to OFF.
2. Unplug stand mixer or
disconnect power.
3. Lift the front of the pour shield
clear of the bowl rim and
pull forward.
4. Remove attachment and bowl.
To use pouring Shield
1. For best results, rotate the shield
so the motor head covers the ?u
shaped gap in the shield. The
pouring chute will be just to the
right of the attachment hub as
you face the mixer.
2. Pour the ingredients into the bowl
through the pouring chute.
6 |
ACEC
