54804-gb.fm5 Page 14 Thursday, April 5, 2001 6:04 PM
INSTALLATION
Warning: Do not connect to the power The oven must be connected to the
supply before you have finished electricity supply by means of an all-pole
connecting the oven and the cooktop.disconnect switch with minimum contact
Make sure the oven is installed and gap of 3 mm.
connected to the electricity supply by a The appliances must be earthed by law.
qualified technician in accordance with Do not use multiple plug adapters or
the manufacturer?s instructions and in extension leads.
compliance with local regulations.
After the oven has been installed, the
The installer is responsible for the coelrrect ectrical components must be
electrical connection of the oven and the inaccessible.
observance of the relative safety
prescriptions.
ELECTRICAL CONNECTION
See separate installation instructions supplied with the cooktop.
Electrical connection between different
models of hobs and oven
B
Attention: The figures represent the right hand B
section of the oven, seen from the top, with the C
C
observer standing in front of the oven door.
Put clamp ?B? into the first holes of junction
block ?C? starting from the left (as shown).
Connect the earth wire (D) of the cooktop to
the oven (E) as illustrated.
B
C
Mount the corresponding knobs in the
control panel last
4 gas burners hob: position of the knob3 gs in as burnethe rs/1 electric hot plate hob: position of
front controls hobthe knobs in the front controls hob
Glass ceramic hob (with 2 double cooking zones):
Glass ceramic hob: position of the knobs in the
position of the knobs in the front controls hob
front controls hob
14 |
ACEC
