To set the Timer to turn on the air conditioner, keeping
Filter Monitorprevious settings:
1. Turn off air conditioner.
1. When Filter Monitor indicator light is lit, remove, clean and 2. Press TIMER. Timer indicator light will flash. Display will show
replace air filter. See ?Cleaning the Air Filter.?
remaining hours before the air conditioner will turn on.
2. Press FILTER MONITOR after cleaning and replacing the air 3. Press the plus or minus TEMP button to change the delay
filter. This resets the filter monitor.
time from 30 minutes to 24 hours.
4. After 5 seconds, Timer indicator light will remain on. Display
will show the current room temperature.
To set the Timer to turn on the air conditioner, changing
the previous settings:
1. Turn on air conditioner.
2. Adjust the mode to Cool, Dry or Fan.
3. For Cool mode:
NOTE: After 360 hours of fan operating time, the filter indicator  Adjust fan speed to High, Med, Low or Auto.
light will turn on. It will remain on for 180 hours or until you press
FILTER MONITOR. After 180 hours, it will turn off automatically. Adjust temperature between 64oF and 90oF (18oC and
32oC).
Temperature 4. For Fan mode, adjust fan speed to High, Med or Low.
NOTE: In Fan mode, temperature cannot be set.
 Press the plus TEMP button to raise the temperature. Each
5. For Dry mode, adjust temperature up or down by 4oF (2oC).
time you press or hold the plus TEMP button, the
temperature will go up 2oF (1oC) until it reaches 90°F (32°C).6. Turn off air conditioner.
NOTE: After 5 seconds, the display will show the current 7. Press TIMER. Timer indicator light will flash. Display will show
remaining hours before the air conditioner will turn on.
room temperature.
8. Press the plus or minus TEMP button to change the delay
time from 30 minutes to 24 hours.
9. After 5 seconds, Timer indicator light will remain on. Display
will show the current room temperature.
To clear Timer delay program:
NOTE: Air conditioner can be either on or off.
1. Press TIMER once after it has been programmed. Display will
show remaining time.
2. While the display is showing the remaining time, press TIMER
 Press the minus TEMP button to lower the temperature. Each again. Timer indicator light will turn off.
time you press or hold the minus TEMP button, the
temperature will go down 2oF (1oC) until it reaches 64°F To see or change the remaining time (in hours):
(18°C).1. Press TIMER once after it has been programmed. Display will
show remaining time.
NOTE: After 5 seconds, the display will show the current
room temperature.2. While the display is showing the remaining time, press the
plus or minus TEMP button to increase or decrease the time.
3. After 5 seconds, the display will show the current room
Timer Delay
temperature.
To set the Timer for a 30-minute to 24-hour delay until the
air conditioner turns off (the air conditioner must be On):
1. Press TIMER. Timer indicator light will flash. Display will show
remaining hours before the air conditioner will turn off.
2. Press the plus or minus TEMP button to change the delay
time from 30 minutes to 24 hours.
3. After 5 seconds, Timer indicator light will remain on. Display
will show the current room temperature.
11 |
ACEC
