De-icer control
Your Whirlpool dehumidifier is equipped with a
feature to help you get the most comfort from
your new appliance by permitting it to operate
Product Damage Hazard down to 55°F (12.8%). ff your dehumidifier runs
Do not operate dehumidifier at tempera- when room temperature and humidity conditions
tures below 55°F (12.8%). are low, frost can form on its evaporator coil. This
interferes with proper operation.
Failure to follow the above precaution could
resuft in the coils icing over and the unit not The De-icer Control senses frost build-up on
the evaporator coil and automatically shuts off the
operating properly. compressor. The fan continues to run, drawing air
across the coil and melting the frost. When the
coil is defrosted, the compressor is automatically
restarted, and dehumidifying is resumed.
Adjusting the water level control lever
The Water Level Adjustment can be set in two
positions to turn off the unit automatically when
the pan is full. This prevents the danger of
overflow.
Pan must be in proper position for Water Level
Control Switch to work. The Water Level Control
Switch will automatically turn off the dehumidifier
at the fill level you selected when pan is properly
placed. Loosen the screw to move the Water
Level Control Lever. Retighten screw when
adjusted to desired setting.
NORMAL fill position Water level
control lever
Set Water Level Control Lever to the indentation
on the left side. The water pan and water will
weigh approximatefy 16 Ibs. (7.2 kg) and water
pan will be lh full.
MAXIMUM fill position
Set Water Level Control Lever to the raised area
on the right side. The water pan and water will
weigh approximatefy 24 Ibs. (10.6 kg) and water
pan will be VI full.
Normal fill Sciew Maximum
position fill position
10 |
ACEC
