Quick Reference GuideGB
Daily check listUpper rackLower rack
1. Arrange crockery so that items do
Crockery holders:
not touch each other.
2. Load cups at an inclination to Down: cups and long-stemmed
facilitate water circulation.glasses.
3. In general, place the cutlery in tUphe : plates.
basket with the handles positioned
downwards, but ensure that sharp
knives and forks that might cause
injury are placed in the basket with
the handles positioned upwards.
4. Make sure the water jet can reach
all loaded items and that the spray
arms turn freely.
5. Turn on the water supply tap befoCutlere ry holder for long utensils:Half load button / Multizone:
starting the dishwasher.Loading the lower rack only
Up: glass holder (gently lift up and
Importantrelease).gives greater washing power,
Switch off the dishwasher once the Down: large cutlery (gently lift up).especially for plates and saucepans.
?Star?t indicator lamp has Place knives with blades facing Cutlery basket:
switched off. If you switch off the
downwards.The cutlery basket can be removed to
dishwasher during a wash cycle,
when switched on again the increase available space.
dishwasher resumes the cycle from
where it was interrupted.Half load button / Multizone:
If a fault occurs or you wish to If only the upper rack is to be loaded,
change the current programme, remove the cutlery basket from the
press th?e START ? button for about lower rach and place it in the upper one.
5 seconds until the Start indicator
lamp switches off ! Refer to the Glass holder:
?Troubleshooting Guide? in these Height adjustment:Plate holders:
The glass holder can be moved
user instructions to remedy any (The dishwasher is delivered with the The plate holders may be removed
sideways.problems.upper rack in the top position).to increase available space.
If regeneration salt is to be Below: small glasses. To remove: pull the handle up.
added, IMMEDIATELY start a Above: long-stemmed glasses.To reposition: simply insert in the
The rack height can also be changed
washing programme, to required position (normal or
when loaded.
eliminate any residual salt.crosswise).
To lower: pull out the two side
Sometimes even when the
regeneration salt container is full, handles and gently lower the rack.
the corresponding indicator To raise: pull up the two side
lamp may illuminate during the handles until the rack clicks into
first wash cycle.
place.
The rack must be level on both
sides. |
ACEC
