NC
INSTALLATION
Only for GERMANY, SWITZERLAND AND
AUSTRIA
AîIftheworktopismadeoutofwood,b
use the springs provided.
1. Fit the four springsb into the relative
housing under the box.
2. Make an opening in the worktop, respecting
the dimensions indicated in the enclosed
product description sheet.
3. Install the cooking hob in the worktop.
BîIftheworktopismadeoutofmarble
or other materials �plastics, ceramics or
stoneO, the cooking hob must be fastened by
means of special brackets, to be ordered
from the AfterîSales Service �code 4819 310
18528O.
Electrical connection
xTheelectricalconnectionsmustcomply
with local regulations.
xThedatarelevanttothevoltageandpower
absorption are indicated on the rating plate.
xTheearthingofthisapplianceis
compulsory by law.
The manufacturer cannot be held
responsible for injury to persons or
animals or damage to property arising
from failure to comply with these
requirements.
xWhenthecookinghobisinstalled,
provide a singleîpole circuit breaker
with a contact breaking distance of at
least 3 mm.
xIfnecessary,theelectricalpowercable
must be replaced exclusively with a
power cable having identical
characteristics to the original supplied
by the manufacturer. This operation
must be performed by Customer Service
or a qualified electrician.
Connection to gas supply
The gas supply system must comply with
local regulations �see paragraph oNational
safety regulationsóO.ab
The connection of the cooking hob to the gas
pipe network or gas cylinder must be made by
means of a rigid copper or steel pipe with
fittings complying with local regulations, or by
means of a continuousîsurface stainless steel
hose complying with local regulations. Interpose
gasketb in the elbow connection.
Themaximum length of thehoseis2m.
Important: if a stainless steel hose is used,It must pass through an area where there
it must be installed so as not to touch anyare no obstructions and where it is
movable part of the furniture.possible to inspect it on all its length.
16
MY
16 GB 67872/C |