? This function is particularly useful if you want to
CONSUMPTION DATALID LOCK
postpone spinning to a later time, or if you want
Temperature SelectorLoadWaterEnergy Approx. Programmeto drain only.For safety reasons, the lid is locked during certain
ProgrammeDurationNote: The programme with ?Rinse Hold? stops phases of the cycle. At the end of the cycle or
(°C)(kg)(l)(kWh)(hours : minutes)*when the ?Rinse Hold? indicator light flashes on the during an interruption, the lid unlocks automatically
?Programme Sequence Indicator?.after about 1 minute.
Cotton955.047**1.602:20
Appliance in ?Rinse Hold?:
Cotton605.0450.952:20END OF WASH CYCLE
? Press the ?Rinse Hold? button again: the
Cotton+Eco***605.0450.852:30programme will terminate automatically with ? The remaining time is on ?0: 00? and the ?End?
Coloured Cotton405.0450.702:15the selected spin cycle.lamp lights up.
Synthetics602.055**0.801:30? If you do not wish to spin the clothes, turn the 1. Turn the programme selector to the ? ?
position.
Synthetics402.0500.501:15programme selector knob to the ?Drain?
programme and press the ?Start/Pause? 2. Turn the tap off.
Daily Mixed403.0450.451:00
button again.3.Open the lid and the drum doors and unload
Rapid303.0350.400:30
?Spin Speed Reduction? buttonthe machine.
Delicates401.5500.500:45? Every programme has an automatically allocated
CHANGE THE PROGRAMME OR OPTIONS
Wool401.0550.600:45maximum spin speed.
DURING THE CYCLE
Handwash301.0400.400:35? Press the button to set another spin speed.
?If the spin speed ?0? is selected, the final spin is 1. Select the new programme using the
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in cancelled, but not the intermediate spins. The programme selector. If necessary, select the
the table in relation to the water supply pressure and temperature, the load and the type of wash.programme ends with a drain cycle.additional options and the spin speed. The
* The remaining time indicator can similarly deviate from the values in the table, because it takes into account the luminous indicator of the ?Start/Pause?
household conditions applicable at that time.START DELAYbutton flashes.
** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains Note: the ?Start Delay? and ?Prewash? options
the water out.The ?Start Delay? button allows the user to run the
*** Reference Programme for Energy Labelmachine at his convenience, for example at night cannot be selected after a programme change.
?Easy Ironing? buttonwhen electricity is cheaper.2.Press the ?Start/Pause? button. The new
PREPARATION OF WASH CYCLEprogramme selected continues at the same
? Can be used together with ?Cotton?, ?Synthetic? ? Select programme, temperature and options.
1. Close the drum doors and check that they are and ?Daily Mixed? programmes to make ironing ? Press the ?Start Delay? button several times to position where the previous programme was
properly locked.easier.interrupted.
select the delay time by 1 to 19 hours;
2. Add detergents and additives into the dispenser to Note: Do not add detergent for this
? Increases the water quantity in rinsing and the ?Press the ?Start/Pause? button. The indicator
no more then the ?MAX? level mark, as follows:clothes are spun in a softer manner.light of the ?Start/Pause? button lights up and programme.
? Programme with pre and main wash
?Eco? buttonthe lamp of the ?Start Delay? button flashes.PAUSE/INTERRUPT A PROGRAMME
? Main wash programme without prewash? The time delay indication disappears when the
? With a modified temperature profile and a slightly
? Fabric softeners and conditionersprolonged washing duration, the optimum programme starts and is replaced by the If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:
? Chlorine bleachcombination of excellent washing result and even remaining time.
1. Press the ?Start/Pause? button. The light
? Stain remover agentslower energy consumption can be achieved.? The number of hours preselected can be reduced flashes.
? Anti-scale agents (if necessary)?Prewash? buttonlater by pressing the ?Start Delay? button again.
2. After the desired pause, press again on the
3. Turn the programme selector knob to the ? Only for heavily soiled loads (for example sand, To cancel the ?Start Delay? option
desired programme. granular dirt).? Turn the programme selector to the ? ? ?Start/Pause? button.
The remaining time display shows the duration of position.CANCEL PROGRAMME
the chosen programme (in hours and minutes) ?Intensive Rinse? button
? Reselect the desired programme and options
and the indicator light of the ?Start/Pause? ? The amount of water is increased to ensure a and press the ?Start/Pause? button.1. Set the programme selector to ?Drain?.
button flashes. more intensive rinse.2. Press the ?Start/Pause? button to start the
The programme sequence and the predefined ? This option is particularly suitable for areas with PROGRAMME START?Drain? programme.
spin speed indication corresponding to the very soft water, washing baby linen and people Turn on the tap and press the ?Start/Pause?
selected programme lights up. with skin allergies.button. The indicator light of the ?Start/Pause?
The preselected temperature can be altered by ?Rinse Hold? buttonbutton lights up. The indicator lamp shows the
pressing the ?+? or ?-? button.sequence reached by the programme. After
? The laundry remains in the last rinse water
starting the programme, the programme sequence
SELECT THE DESIRED OPTIONwithout progressing to the final spin cycle to avoid
creasing and prevent colours from fading.indicator signals the Wash, Rinse and Spin phases.
When you select an option authorized by the Note: If there is a power interruption or if the
? This option is particularly recommended for the
programme, the corresponding indicator lights up, ?Synthetic?, ?Delicate? and ?Daily Mixed? appliance is disconnected during the cycle, the
except if the combination of programme, programme will run again from the point where it
programmes.
additional options and temperature is not possible.was interrupted.
Whirlpool is a registered trademark of Whirlpool USA.
5019 312 10333 |
ACEC
