INSTALLATION INSTRUCTIONS
INSTALLATION
Install the appliance on a solid and level floor
surface, preferably in a corner of the room.
Make sure that all four feet are resting firmly on
the floor and check that the appliance is perfectly
level (use a spirit level).
If the floor is uneven, adjust the levelling feet as
required (do not insert pieces of wood, cardboard
etc. under the feet).2
1. Slacken the locknut using the spanner supplied.
2. Adjust the height of the foot, turning it by hand.
3. Tighten the locknut anticlockwise towards the 1
washing machine.
If the appliance is to be installed on a wooden floor,
distribute the weight by placing it on a 60x60 cm
sheet of plywood at least 3 cm in thickness. Secure
the plywood sheet to the floor.
3
BUILD-UNDER / WORKTOP
1
The appliance must be installed only under a
fitted, continuous kitchen worktop.
The appliance must only be built under using the
built under set UBS.
Unplug the appliance from the mains.
1. Unscrew the worktop fixing screws from the rear
of the appliance.
2. Slide the worktop fully backward and lift it
upwards to remove.
Install the cover panel following the relative
instructions.
3. Refit the fixing screws and tighten them.
2
3
BUILD-UNDER OPENING DIMENSIONS
Width600 mm
Height825 mm
Depth600 mm
WARNING:
Only plug the machine into the mains power socket
after you have fitted the cover panel or the machine
worktop.
75 |
ACEC
